Hello! The Hazard Switch/Module connector has the following wires of interest...Pin G=Dark Blue (right side lights)...Pin F=Light Blue/Black (left side lights)...Pin H= Purple (flasher battery)...And Pin A=Black (ground)...In order for the lights to flash, without pressing the switch, Flasher Battery must be applied to Pins G and/or F...When the problem occurs are all external lights flashing or just one side? Visually inspect the connector for bent pins and the harness for bare or frayed wires...If you have a multimeter and a wee bit of experience using it; Set the ohm meter to X10 scale...Measure from Pin A (black wire) to the center of the negative battery post...Reading should be zero ohms or very close to it...Send results...
Guru.......saailer
I’m happy to help further over the phone at https://www.6ya.com/expert/david_6df67de3b14de867
314 views
Usually answered in minutes!
×