this blower motor has gone 3 times in the last year and a half . I hvae heard it is simple to replace yourself but how do i do that where is it located picture s maybe?/
this blower motor has gone 3 times in the last year and a half . I hvae heard it is simple to replace yourself but how do i do that where is it located picture s maybe?/
You can't post conmments that contain an email address.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
? 2:28
https://www.youtube.com/watch?v=zUu256ADwJA
Jun 2, 2012 - Uploaded by 1chrisrg
U know how to adjust idle speed manually on 2000 mercury cougar? ... You may drive and the hole is too small and the coug will stall. .... I replaced the IAC and now if sounds like my engineis in a race ... I just bought a 99 Cougar. ... new edge cougar owners forums and I believe there are directions on ...
? 5:01
https://www.youtube.com/watch?v=abBINs_zWh8
Jul 12, 2013 - Uploaded by kirk colombo
02 explorer - remove dash panel and replace heater and air conditioning control switch knobs. Can also ...Missing: cougar ‎stalls
Typically you will find the blower motor on any vehicle in one of two places. Look on the passenger side fire wall. If it is not there then it is most likely one the inside under the glove box on the passenger side. Be aware that blower motors can be difficult to change depending on their location and what else must be removed to get to them.
YOU HAVE TO REMOVE ENGINE AND TRANSMISSION AS ASSEMBLY SUPPORT ENGINE AND TRANSMISSION FROM UNDERNEATH VECHICLE WITH A DRIVE TRAIN SUPPORT TABLE. THEN RAISE VECHICLE BODY UP FROM ENGINE AND TRANSMISSION WITH A LIFT.YOU NEED ENGINE LIFTING BRACKETS 303-050 SUPPORT ENGINE WITH SHOP HOIST.
It is located on the right side of the motor. You have to remove the air filter box, and battery to get to it. You have to take it out from the top side. It's a tight fit but can be done without too much problems. I replaced mine twice. You have to work pretty much blind, and by feel. This will save you at least $100.00 in labor.
remove the trim panel below the glove box and you will see the blower motor,just to the left of it you will see a 4 wire connector plugged into the case. This is the blower motor resistor,this is what you need to replace.
Thanks alabama! Cant use my garage so Im in the the driveway, its cold (Jan. in Indiana) and I don't have alot of patience right now. Again thanks very much for sharing!
this blower motor has gone 3 times in the last year and a half . I hvae heard it is simple to replace yourself but how do i do that where is it located picture s maybe?/
×