Clutch kit mazda drifter 2.5 diesel turbo d/cab 4 x 4 model 2002

You have to dismantle the gearbox to get too the synchro,s.

type your question into google and click images might take you a whileto find but should be on there.

press the helpful button and try links below

http://www.aera.org/uploads/4/3/7/7/43776611/aera-torquespecs.pdf

mazda ford diesel rf r2

I have a Toyota Yaris 2004 plate. The cold light stays,the fan kicks in and stays on, but the cold light does not go off. Help please. regards M Barrett

• Tappet clearence for Mazda 2.5 diesel turbo 2002 model

check your alternator and your starter.I would bet either one of them is your problem

incorrect ignition point for the injectors
diesels ignition point is around 22 degrees btdc for pumps or from the crank sensor if common rail ( information of year or pump or common rail not included )
if it is a pump with pipes to injectors , you have the timing incorrect

Mazda B2200, B2500 and B2600 (6th Generation).

In model year 1998, Mazda B series renews its own international markets. Production at the plant AutoAlliance Thailand began in May 1998. This model is also sold as the Ford Ranger in Europe and Asia, and the Ford Courier in Australia and New Zealand. Production started this year in the factories of companies AutoAlliance Thailand and Ford Motor Philippines. Versions CKD are also assembled in South Africa, Ecuador and Colombia.

The van is sold in over 130 countries under a variety of names. Along with the emblems of Fighter and Ranger in Southeast Asia (except Singapore, which served as the flagship models Proceed Japan), was sold as the Mazda Bounty and Ford Courier in New Zealand, Mazda Bravo in Australia, and Mazda Drifter in South Africa.

Engine options:
2.2 L 2.2 L (2.184 cc) 85 hp (63 kW)
2.5 L (1.998 cc) turbo diesel 118 hp (88 kW)
2.6 L (2.606 cc) 121 hp (90 kW)

Fig. Tighten the exhaust manifold bolts in 2 stages

To install:

1. Clean the mating surfaces on the exhaust manifold and the cylinder head.
   
2. Install a new gasket and the exhaust manifold. Torque the bolts in sequence as follows:
   1. 16 ft. lbs. (23 Nm).
      
   2. 59 ft. lbs. (80 Nm).

Hope helps.

Bleed the hydraulic system. Check the hydraulic lines, it could be swelling, Did you change the pilot bearing as well? If it was removed and not replaced, there will be a hard vibration.

http://jdmultimate.com/Store/Product/ItmItem.aspx?ItemId=176995&Make=MAZDA&Model=B2500
There you go if you need anything else let me know. I hope you find this appropriate for a FixYa rating.
Thanks,
Lee