Question about 1992 Isuzu Rodeo

1 Answer

Is the 1992 isuzu rodeo, automatic - fuel injected? that is, do you need to give it any gas to start?

Posted by Anonymous on

Ad

1 Answer

Duane Wong

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Isuzu Master
  • 6,826 Answers

No, you don't have to press the accelerator in fuel injected engines. That's a general rule for all fuel injected engines.

Carbureted engines require that you push the accelerator slightly when starting.

Good luck on using your fuel injected vehicle.

Posted on Nov 05, 2010

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

92 rodeo no in injectors


I have a 1992 Isuzu Rodio 3.1 injectors not working; but if i put gas in the throttle body it will start up and run. but while driving it down the street it will die and not re-start, until i put gas in the throttle body. the nod light does not work when it wont start. please can you help me with this problem, i have put a new fuel pump in it and two new injectors.

Oct 28, 2011 | 1992 Isuzu Rodeo

2 Answers

1993 rodeo not running no power to fuel pump


if there is no power to the fuel pump check relays and fuses....UNDERHOOD FUSE & RELAY PANEL IDENTIFICATION Fig. 2: Underhood Fuse & Relay Panel Identification Courtesy of ISUZU MOTOR CO. Fusible Link Identification ? A - 80 Amp (1991-92 3.1L) ? A - 60 Amp Main-1 ? B - 30 Amp Main-2 ? C - 30 Amp (1993-94) ECM (3.2L) ? D - 30 Amp Condenser Fan (A/T Models) Relay Identification ? 1 - Headlight Relay ? 2 - A/C - Heater Relay ? 3 - Starter Relay ? 4 - A/C Compressor Relay ? 5 - Charge Relay ? 6 - Fuel Pump Relay ? 7 - ECM Relay ? 8 - Wiper Relay Fuse & Circuit Breaker Identification ? 1 - 15 Amp (1991) ECM, Fuel Injection System ? 1 - 15 Amp (1992-94 2.6L) ECM, Fuel Injection System ? 1 - 10 Amp (1992-94 3.1 & 3.2L) Heated Oxygen Sensor, Fuel Injection System ? 2 - 20 Amp (1991-92) Fuel Pump ? 2 - 20 Amp (1993-94 2.6L) Fuel Pump ? 2 - 15 Amp (1993-94 3.2L) Fuel Pump ? 3 - 10 Amp (1991) ? 3 - 15 Amp (1992-94) Turn Signal Lights, Hazard Warning Flasher Lights ? 4 - 10 Amp Horn, Door Locks ? 5 - Not Used (1991 3.1L) ? 5 - 10 Amp Charging System, Charge Warning Light WARNING: Always disconnect battery ground cable before servicing "high- current fuses. It is recommended that "high-current" fuses be replaced by a qualified technician. Page 1 of 2 FUSES & CIRCUIT BREAKERS -1994 Isuzu Rodeo LS? 6 - Not Used (1991) (1992-93 2.6L) ? 6 - 10 Amp (1992-94 3.1L & 3.2L) A/T Interlock System ? 6 - 10 Amp (1994 2.6L) Heated Oxygen Sensor, Fuel Injection System ? 7 - 20 Amp Heater/Air Conditioning Blower Controls ? 8 - 10 Amp Air Conditioner Compressor Controls ? 9 - 10 Amp Right Headlight ? 10 - 10 Amp Left Headlight © 2008 Mitchell Repair Information Co., LLC.
62217_isuzfuse_1.jpg
Underhood fuse block swap out relay #7 thats the ECM relay.
Ground Circuits Using a DVOM, touch negative voltmeter lead to a good ground. Touch positive voltmeter lead to each ground terminal. With vehicle running, voltmeter should indicate less than one volt. If reading is greater than one volt, check for open, corrosion and loose connection on ground lead. See ECM GROUND LOCATION table for ECM ground location.
Page 1 of 1 SYSTEM/COMPONENT TESTS - 2.6L EFI -1994 Isuzu Rodeo

Mar 28, 2010 | 1993 Isuzu Rodeo

2 Answers

My 1994 isuzu rodeo seem to be losing power it start when my gas cap got stolen. I drove it for about 2 day with out a gas cap then it start to act as if was losing power.


this is a comen problem your fuel system is fuel injected and needs to be a sealed , with out the corect presure the fuel is not deliverd properly ,i would sugjest a factory gas cap to insure proper pressure hope this helps

please post responce

Jan 07, 2010 | 1994 Isuzu Rodeo

1 Answer

How do you put a 1992 isuzu rodeo back in time?


you mean the timing chain broke??? you will need it replaced and when they do that, it will be back in time.

Sep 23, 2009 | 1992 Isuzu Rodeo

1 Answer

99 Rodeo 3.2 V6 fuel injected .


sounds like u may need a new fuel pump, the problem is the system doesn't hold fuel pressure after shut down, the check valve that does this is part of the fuel pump in the gas tank.

Jun 10, 2009 | 1999 Isuzu Rodeo

1 Answer

Where is the fuel filter in my 1992 Isuzu Rodeo?


Look on passenger side frame rail ahead of the rear wheel in a bracket with a fuel line on each end. Before starting replacement-- be sure to release pressure from fuel lines, by removing fuel pump fuse under hood and running engine to use gas from lines. I then remove fuel lines by moving clamps away from fitting so hose can be pulled loose from old filter while it is still in bracket. On top of mounting is a bolt that holds filter clamp in place . After removing clamp and filter from mounting bracket, loosen filter body clamp and slip oout old filter-- then in with the new filter. Then reverse your steps to install filter. After filter is back in place -- reinstall fuel pump fuse, turn on key for a few seconds for gas to refill lines, then start engine and check your installation to make sure you have no fuel leaks at line connections.

Oct 18, 2008 | 1992 Isuzu Rodeo

1 Answer

1991 isuzu rodeo 2.6 engine.)


You have a very dangerous condition. Do not start engine. Problem is in fuel injection system. Probably cold start valve stuck wide open and dumping excessive gas in system. Have car TOWED to shop. Bill

Oct 04, 2008 | 1991 Isuzu Rodeo

Not finding what you are looking for?
1992 Isuzu Rodeo Logo

Related Topics:

234 people viewed this question

Ask a Question

Usually answered in minutes!

Top Isuzu Experts

Marvin
Marvin

Level 3 Expert

85239 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14846 Answers

Are you an Isuzu Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...