Cars & Trucks Logo

Related Topics:

Question about Mitsubishi Mirage

1 Answer

My door remote thingy is broken and i can't lock it nor can i drive it without the alarm going off. Can i disable the alarm somehow?

Posted by rain_in_a_te on

Add Your Answer

1 Answer

Anonymous

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points
    Superstar:

    An expert that got 20 achievements.
    All-Star:

    An expert that got 10 achievements.
    MVP:

    An expert that got 5 achievements.

  • Master
  • 4,793 Answers

NO WAY,you have to have a remote to set/unset the system.(if you could, so could any tom,****.harry.)so you know, the key has ONE code,(constant)the car has two codes,one rolling and one constant)the remote searches for the rolling code and then disarms it,so that when you put the key in it starts.....then when you lock with the remote it reactivates a different code,simple but effective deterrant for thieves.....and other mitsi owners.

Posted on Oct 26, 2010

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

I assume the factory alarm was somehow bypassed when they installed the remote start is there a way I can make the factory alarm work when the doors are opened without key,?
To arm content theft alarm.
1. Open the door.
2. Lock the door with the power door lock switch or
the remote keyless entry transmitter. The
SECURITY light should flash.
3. Close all doors. The SECURITY light should go off
after approximately 30 seconds. The alarm is not
armed until the SECURITY light goes off.

If a locked door is opened without the key or the remote keyless entry transmitter, the alarm will go off. The headlamps and parking lamps will flash for two minutes, and the horn will sound for 30 seconds, then will turn off to save the battery power.
Read full answer
Jun 24, 2021 • GMC Cars & Trucks
1helpful
2answers

The alarm turns on when I put the key is in the door lock. Is there alarm reset?
Are you using an aftermarket key or the original? It may have a chip in it. Also if you have a spare original try it.
Read full answer
Jan 22, 2015 • 2009 Nissan Versa Hatchback
0helpful
1answer

How disable my alarm system on rover 45 td
I've just fixed the same issue.

100% that the cause is the condition of wires connected to the lock on trunk. (if the 4 switches at doors and the one sensor under the hood works fine)

I've disconnected wires, took of lock, cleaned lock mechanism and sensors, 'reformed' little copper thingy (connected to one of the wires - reformed to not to connect it both positions) and now I can sleep all night long without hearing beep-beeps...

It takes about 10 minutes and the only tools you need is a wrench and some WD40...
Read full answer
Nov 19, 2011 • Cars & Trucks
0helpful
2answers

Nubira keyless remote is broken, how can I disable immobiliser with key only
Put the key in the dr. door lock and lock and unlock the door. This should turn the alarm off.
Read full answer
Mar 28, 2010 • 2001 Daewoo Nubira
0helpful
1answer

I just bought a 1996 jeep grand cherokee larado, I locked the doo while inside with electric lock switch on door. I then opened the door with the handle. the alarm went off which I did not know it had. I...
lock with key,electric door lock button,or remote and alarm will set. to disarm you have to use the key or remote to open it.the reason it woulnt disarm from drivers door is either the door lock cylinder switch is broken or the wire to it in the rubber boot that connects the door and the body is broken.
the remotes are cheap and programing is easy,procedure in owners manuel something like lock drive door with elkect. lock switch with door open then push and hold unlock untill doors unlock then turn key off.you may have to fix that drive door lock cyl.switch first though mabee not dont know for sure
Read full answer
Mar 22, 2010 • 1996 Jeep Grand Cherokee
0helpful
1answer

Can't lock my Honda Accord as alarm goes off when locked
if you have a valet key, stick it it on the passenger side when unlocking door, so it wont alarm while you open the door hope that helps
Read full answer
May 17, 2009 • 1998 Honda Accord
0helpful
1answer

Locking mechanism is broken on driver's door.
If the valet key is not programmed to the Immobilzer system, it should start the car, but it will shut off. This is only if the car has an Immobilizer system. If your locksmith unlocked the car without the door key, then use the key to unlock and disarm the alarm in the door. If you triggered the alarm, the starter will be disabled till a unlock signal from a remote or the door is actually unlocked with a key. If that cannot be done, your only solution right now is to tow it to the dealership and have them make a master key and check the door locks for proper lock/unlock commands so the alarm will arm and disarm correctly.
Read full answer
Apr 25, 2009 • 1998 Audi A6
1helpful
1answer

Alarm for audi A4
Try disarming the car from the trunk. Sounds like the door lock switch is not deactivating the alarm, which it should, with or without the remote.
Read full answer
Apr 24, 2009 • 2001 Audi A4
2helpful
3answers

How to disable alarm system
I have 96 dodge caravan and I need to disable the alarm system too and I don't know how!
Read full answer
Apr 20, 2009 • 1996 Dodge Caravan
0helpful
1answer

1994 jeep grand cherokee
You cant disable it realy..but you can use the key to unlock the driver door or the rear door. Both have a alarm shut down wire..Also that wire could be broken in the drive door boot...very common. The wire is purple and yellow..Touching the wire to ground shuts the alarm off. Just make sure if its broke that the end going into truck is the one you groung on the frame. Also locking the doors from the inside with the driver door open is what activates the alarm. That wire can also be found in the drivers side kick panel.....
Read full answer
Jul 18, 2008 • 1994 Jeep Grand Cherokee
Not finding what you are looking for?

View Most Popular

Cars & Trucks

Related Question

I assume the factory alarm was somehow bypassed when they installed the remote start is there a way I can make the factory alarm work when the doors are opened without key,?

  • GMC Cars & Trucks

Open Questions:

0answers

Mitsubishi Pajero GDI accelerates too much! When I am on the road my Pajero GDI increases acceleration on its own. It feels like it will fly, and then loses power.
Read full answer
Be the first to answer Feb 02, 2022 • Mitsubishi Pajero Cars & Trucks
0answers

Does a 2004 Mitsubishi Endeavor AWD, have a transmission fluid filter?? If so, where is it located and how to get to it???
Read full answer
Be the first to answer Jan 22, 2022 • Mitsubishi Cars & Trucks
0answers

What size socket do i need to get a 2003 mitsubishi starter wire off I have the intake off and im trying to take just the cable off to replace it and i need to know what size socket will do it
Read full answer
Be the first to answer Dec 25, 2021 • Mitsubishi Cars & Trucks
0answers

Put a new rotor cap on and noticed a wire hanging down underneath. It has 3 wires going out of it. What could it be? 1989 Mitsubishi mighty max, 2.0
Read full answer
Be the first to answer Oct 24, 2021 • Mitsubishi Cars & Trucks

238 views

Ask a Question

Usually answered in minutes!

Popular Questions

Carburetor Tuning Mitsubish.

1992 Mitsubishi Mirage

Que significa SRS en el panel de mi mitsubishi mirage 1995

1995 Mitsubishi Mirage

How to change out flasher fuse

1995 Mitsubishi Mirage

My 1994 Mitsubishi Lancer (4g15) engine stops

1994 Mitsubishi Mirage

MAP sensor output voltage too low?

1993 Mitsubishi Mirage

Check Out the Latest Top Trucks Report!
Check Out the Latest Top Trucks Report!

View all Fixya Reports

Top Mitsubishi Experts

Marvin
Marvin

Level 3 Expert

85241 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22516 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15087 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...