My 91 eagle talon is making this squealing noise only when i am stopped or barley pulling off. It will start at 2 rpm and stop when I hit 10-15 mph. I have 2 lights on one is the battery light and the other one looks like a house??? When I slow down the lights come on and when I go fast they go off.

What is causing that irritating noise? ' DSMtuners

www.dsmtuners.com > ... > Articles: Miscellaneous
Jun 1, 2009 - 2 posts - ‎1 author Check the ECU power relay in the console, under the radio. ... You hear a loud clicking type noise from under the hood when you try to start the car. .... You hear a squealing, grinding, or rubbing noise in the lower timing belt .... The Mitsubishi Eclipse, Eagle Talon, Plymouth Laser, Mitsubishi Galant VR-4, ... LOUD squeak when turning steering wheel (Video Inside)
22 posts
Mar 5, 2011
Why does my alternator belt squeal so much on initial ...
25 posts
May 14, 2010
More results from www.dsmtuners.com

Lancer Troubleshooting [Archive] - evolutionm.net

www.evolutionm.net/forums/mitsubishi-evolution-forums/f-203.html

NEED RADIO HELP! ... Help not start Lancer GT 2012 EngineOverheating STOP SAFELY warning on ... AC ISSUES 2011 Mitsubishi Lancer ES · 2008 Lancer GTS no start please ... 2011 lancer no sound · Driver/Passenger side floor squeaky? ... plastic piece of rear shelf rattles a lot · Very loud noise on Lancer ES 2008 ...

its it most likely the wheel bearing had this issue as well changed out wheel bearing and it was good to go

May not be getting enough fuel to the engine

If it's manual it could be clutch slipping but if it's auto then could be a cellenoid that's sticking check trans fluid for dirtiness

The most common reason is the hydraulic valve lifters. The short term fix is to

a) replace the oil and filter if this has not been done recently.
b) Rev the engine to 3000 rpm and hold for 30 seconds. This pumps up the lifters and helps clear old oil.
c) do this 2-3 times until the clicking stops.


The longer term fix is to replace all 16 lifters.


Other more expensive reasons are
a) a big end bearing. This sounds more like a hammer on anvil hit, and its louder if you blip-rev the engine. Rev to say 2000 and back off slightly and the noise stops. The fix is a replacement engine or engine rebuild.

Try spraying your belts with some belt lube. You can pick it up at any auto parts store or even walmart

check and see if the head gaskets are blowed you may have a cracked or blown head or head gasket

Possible bad starter , low voltage in battery meaning dead battery or just bad and corroded connections at battery post and starter. Try cleaning connections and recharge battery if needed.

sounds like the clutch "throw-out bearing" the bad news is the trans must be pulled back to access it ... let it go until it goes

Hi,yes i would say toast.Try this web site www.car-part.com
Good Luck!!!