Peugeot 407 05 reg my abs and esp lights stay on why

wow no year car, now that is a challenge , no?
abs is first.
first- first are brakes.
abs stuck on key on and running full time right?
so check brakes for damage or worn out.
brake fluid level not falling? look yet? look when checking oil every time.
abs can not work on cars with bad brakes, (its not god like)
then check for ABS sensor damage and its wires. under car.
then scan the ABS. got errors, sure you do.
but what? you didnt scan it first.
or read the manual> RTM?
its only 4 bucks to read it.

posted over 200 times, this.
https://suzukipitstopplus.com/Category/3-suzuki-service-manuals.aspx

answer year and read.

possibles
1: horn scars car, or abs, niece said. so....
2: horn is bad causing huge overload on he electrics.
3:low car battery, not charging fully. 12.6vdc rested, 13.3 to 15vdc running.
4: gawd forbid, bad ABS. (i dont believe it)
5: corroded fuses, wires and power feeds to abs , sure.

ABS light coming on,For this get the Engine computer scanned.It can be error codes stored in computer.------------
For more details regarding this click the link below:-----
The ABS and Traction Control Lights stays ON dash of car? http://schematicsdiagram.blogspot.com/2011/06/abs-and-traction-control-lights-stays.html

---------------
And now for clutch not going in gears it can be faulty clutch issue or problem with clutch cable.This has to be inspected.For more detailed instructions regarding Peugeot clutch problem,click the link below:-----
Peugeot 307: Clutch will no go in gears?
http://whoisbyme.blogspot.in/2012/05/peugeot-307-clutch-will-no-go-in-gears.html

---------
This will help.
Thanks.

Those are multiple problems. ABS is antilock brake system. Normally this comes on when you need to replace your brakes. Also replace the engine oil in your car and have your car tuned. The check engine light will more than likely go off. If not then the mechanic will tell you what needs to be done to make it go off. Hope this helps

abs light stays on due to wheel sensor not working or signal getting to the abs module.

Here's an interesting link that describes Bosch ESP and ABS:
http://www.bosch-esperience.com/uk/language1/from_abs_to_esp.html

try taking battery off for half an hour and retry

the stalk should have no interference with the abs or esp set up what i would look at doing is checking your abs sensors they can go all of a flash...goodluck

abs esp warning light coming on peugeot 407

check the fuses by the battery ,the big ones,then the other fuses ,if this fails then don mini and heels and drive to garage

i got exactly the same symptoms on my 407
after spending some time underneath i found that the ABS sensors on the inside of the wheelhubs were covered in road dirt
after CAREFULLY jet washing the area and carefully spraying with WD40 (dont get any on the brakes)
it the lights stayed off

other than that is most likey to be a faulty sensor