I have a k reg 318i 8v and i need to know the torque settings for the head bolts. Thankyou

with the correct torque wrench of course

http://olybrake.com/pdf/fel_pro_torque_specs_guide.pdf

Sorry I don't know but if I were doing that kind of work, I would order a shop manual on line.

Torque settings for cylinder head bolts for Skoda Fabia 1.4 16v

Cylinder head bolts tightening order:



IMPORTANT NOTE: RENEW BOLTS!

Stage 1: Tightening torque = 30 Nm
Stage 1: Tightening torque = 90 Degrees
Stage 1: Tightening torque = 90 Degrees

Please do rate my response. Thanks!

hi to tighten you have to do it in 4 stages as follows
1st stage 40nm leave 5 mins 2nd stage 60nm leave 5 mins 3rd stage 90 degrees leave 10 mins 4th stage 90 degrees then you are done i will try put order on here i hope this works as follows
10 4 2 6 8 front of engine back of engine 7 5 1 3 9

in that order hope this helps

if its a diesel 8v or a petrol then its 40 nm, 60 nm, 90 degree, 90 degree

hi yes here are the torque settings

stage 1 is 25nm
stage 2 is 45nm
stage 3 is turn 105 degrees

try leaving about 10 mins between each torque so it can settle also you have to tighten them in sequence and make sure you use new head bolts as these are the stretch type and if you are using the old ones there could be a chance of one snapping, just a little advice..hope this helped

Hi unsure what you mean by change the torque settings, if you mean on the head question is why? If yes for head, there is a tool for that & go to Download PDF search | PDFTown.com
for more info

80 lbs

Tightening torques

Do not reuse the bolts as they may be stretched.

Cylinder head to engine block
Stage 1: 32Ft-lbs
Stage 2: +90degrees
Stage 3: +90degrees

Cylinder head to lower timing
chain cover: 89in-lbs

According to my haynes manual for G-S reg, 1989-1998 it goes as follows,
Stage 1:- Tighten all bolts by hand until bolt heads just contact cyl. head.
Stage 2:-Tighten all bolts to 40Nm or 30lb ft.
Stage 3:-Angle tighten all bolts a further 60 degrees.
Stage 4:-Angle tighten all bolts again a further 60 degrees.
Stage 5:- M12 x 140mm bolts ONLY angle tighten a further 20 degrees.
Hope this helps everyone, sorry it seems longwinded but that is how it's written in the manual.