Tail lights out brake lights out turn signal blinks right no matter which way you pull lever 01 explorer sport trac

Download the owner's manual from Ford.

could be a faulty globe too

More than likely the "multi-function" switch is bad. It is actually the turn signal, headlamp lever which is affixed to the switch which is located in the steering column.

Just had same issue with my 01 sport trac. Just purchased truck an never noticed until several days later had no tail lights. Brake light on cab worked not on bed. After days of head banging an scratching I realized when steering wheel was tilted up had lights down no lights tore into steering column was an easy easy fix. The clip tht holds harness in place on top of cold was broke an plug had slid out a bit so pushed it in good an tight zip tied it for temp fix vuala tail lights! Wanted to share so if anyone else has issue they didn't have to spend days scratching their head!

Power for the brake lights go thru the turn signal switch before getting to the light bulbs.
Do you have power in and out of the brake light switch and the turn signal switch ?

check brake light switch on brake pedal arm. Does high mount stop lamp work?

blown bulbs,, :) replace the bulbs of it was a fuse you would have a lot more lights not working, was it a bad harness none of the lights on that harness would work so the problem is the bulbs, replace the bulbs.

The ford explorer sport track. Will have a short either at the plug of the multi-function switch or 6 inches down where the column bends the wires during tilt.

Rear lights are double filament bulbs one side for the lights other side for the brake/turn signals so it still may be a bulb. Do u have a test light or volt meter you can check to make sure u have power there when brakes or turn signals are activated. Or just try another bulb.