Question about Mercedes-Benz C230

1 Answer

I have a 2004 mercedes c240 and have a new crank censor to install. Where is the censors location on the 6 cylinder?

Posted by dankramer95 on

Ad

1 Answer

Anonymous

  • Level 1:

    An expert who has achieved level 1.

    MVP:

    An expert that got 5 achievements.

    New Friend:

    An expert that has 1 follower.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Contributor
  • 25 Answers

Pretty sure the sensor is on the top of the gearbox bellhousing, and picks up its pulse from the flywheel on this model, its held in by allen bolts and is easiers to access from underneath the vehicle ( just above starter location

Posted on Sep 19, 2010

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the crank position censor located on a 2004 chevy trailblazer inline 6 cylinder?


Google a picture

Hope you not throwing parts at it,
without doing any testing, to find a
problem or failed part

That could get time consuming & costly
& fix nothing

Codes don't tell you to replace parts

Prove me wrong once, if you like

Then the next ten years it will bite you

Have to learn how things work & how to test them

Sep 29, 2014 | 2004 Chevrolet TrailBlazer

1 Answer

I replaced the timing belt and crank shaft censor on my 2002 sedona.im not getting a fire from my coil packs.i ran a test it said crank shaft censor,tried a new censor..same problem,same results.what could...


it might be this sensor I can't think of the name of it but it is located by the thermostat. it is held on with 2 10mm bolts and has a connector similar to the mass sensor on it. This sensor controls spark.

Oct 17, 2013 | 2002 Kia Sedona

1 Answer

I have a ford falcon AU series one 6 cylinder wagon. It takes ages to get it started but when I does it will idle, but idles rough. When I accelerate it dies. I have changed the injectors, fuel filter,...


Run the fault codes as what you have done may only be by passing the real faulty sensor. Check the cat converter for failure and blocking the exhaust system

Oct 13, 2013 | Cars & Trucks

1 Answer

How many o2 censors in a 2002 6 cylinder chrysler sebring convertible


Should have four, one in front and one after each catalytic converter.

Sep 27, 2012 | Cars & Trucks

1 Answer

Where is the crank censor located


crankshaft position sensor is located on the transmission bell housing on the left side/ driver side of the engine. It reads off the flywheel. You probably have to feel for it because they are hard to see from the top side.

Oct 01, 2010 | Mercedes-Benz E320 Cars & Trucks

1 Answer

Where is the throttle censor located on a 2004 1500 serria


the throttle position sensor is located on the throttle body

assuming this is a gasoline engine

May 11, 2010 | 1995 Chevrolet C1500

1 Answer

Does a dodge ram 1500 have a cam or crank censor?


The 3.9L 5.2L and 5.9L engine use the distributor assembly as your cam sensor . The crank sensor is on right rear attached to engine block (behind cylinder head)

May 08, 2009 | 1996 Dodge Ram 1500 Club Cab

1 Answer

My Jeep shuts off when I step on the brakes.


brake booster check valve leaking.

Apr 30, 2009 | 1994 Jeep Cherokee

1 Answer

2004 mercedes c240 alarm sounds for no apparent reason


Hi, You need to replace the alarm siren. It is also a module. It is located in the right front fender well. The reason they go bad is because they are located in a place where they get wet.

Apr 03, 2009 | 2004 Mercedes-Benz C-Class

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

135 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mercedes-Benz Experts

Marvin
Marvin

Level 3 Expert

85239 Answers

Vincent G
Vincent G

Level 3 Expert

2363 Answers

xxxxxx xxx

Level 3 Expert

5023 Answers

Are you a Mercedes-Benz Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...