Check volume controls/etc on cd player. if volume goes up but no sound, check connections on back of cd player to vehicle wiring harness. if ok, put old radio in to see if sound works. if sound works, the cd player may be bad. if sound does not work with old radio, it's the car's factory installed amp. you can bypass it by running different wires to the speaker location.
Ok any idea where the amp is
the amp is either under the dash on passenger side (where passengers feet go then look up in there or in the trunk under the rear dash.
ok thanks why does that effect the speakers?
is there away to disconnect the factory amp?
×
Check your wiring, make sure its not grounded behind the dash somewhere
yeah i checked that still nothing
no sound with old radio in?
are you putting in an amp and some subs or just the new deck?
yea i planned on putting an amp and a sub in
×
SOURCE: YUKON CD PLAYER NO SOUND!
Is your IP Bus cable on the INPUT and not the OUTPUT ? I know it sounds funny, but usually(95%), that's the case. If it's in the wrong plug, you'll have power and a display, but no audio. That's why your getting data but no audio.
646 views
Usually answered in minutes!
×