I have a 1997 Geo Metro 1.3L that starts but has no power. Can not drive it. The code is P0505 idle control malfunction. I checked the fuel pressure and its ok. Whats next?

Question 1

0helpful

2answers

What is the code for P0505?

P0505 should be the IAC (Idle Air Control) System Malfunction

Hope this helps

Jan 27, 2015 • 2002 BMW 3 Series

0helpful

1answer

Code p0505

P0505 14 ICS Malfunction
http://www.ericthecarguy.com/29-obd-codes/obd-ii-codes/honda-obd-ii-specific-codes/215-p0505-idle-air-control-valve-malfunction-honda

Mar 22, 2014 • 1997 Honda Accord

0helpful

1answer

2002 honda civic code p0505

Error Code: P0505
Fault Location:
Idle Speed Control (ISC) System - Malfunction
Possible Cause:
-Wiring harness.
-Idle speed control (ISC) actuator/Idle air control valve (IAC) valve.
-Throttle valve tight/sticking.
-Engine control module (ECM).

May 13, 2013 • Honda Civic Cars & Trucks

0helpful

1answer

My 1997 geo metro 1.3liter keeps severly flooding with fuel no obd2 codes present

I'm syill working on the problem but I swapped the throttle bore assemby , put new cap & rotor amd double checked the timeing (Both belt & distributer with timing light) and engine still floods,. Wm going th check for kinked return hose next.

May 07, 2012 • 1997 Geo Metro

0helpful

1answer

1997 Geo Metro with throttle body. Will start but no power, not enough to drive car. Will only slowly increase rpm's. After rpm's are higher, you can continually blip throttle and it runs normal...

Visit the on-line store, known as reliable-store, they have the repair manuals. I'm sure you will get the solution of your problem. Best Manuals

Feb 15, 2018 • 1997 Geo Metro

0helpful

3answers

Hello, I hsve a 1997 Geo metro 1.3L motor and it will start and run cold fine but after it warms up it starts running ruff and will even die on me. I have replaced the fuel pump, relay and fuel filter, I...

CHECK FOR VACUM LEAKS AT INTAKE MANIFOLD AND ECT TEMP READING COULD BE OFF,

Apr 13, 2011 • 1997 Geo Metro

4helpful

3answers

When engine gets hot, idle is up and down with the engine light on. OBD code gives a P0505 code.

per this address "http://www.obd-codes.com/trouble_codes/" p0505 is a "IAC (Idle Air Control) System Malfunction" it gives some good suggestions to look at to find a solution for your problem.

Dec 14, 2010 • 2002 Honda Odyssey

1helpful

1answer

My daughter has a 1997 geo metro LSI 4 cylinder, and the car will run fine then ususaly at idle it will start to run rough. By putting in nutrail and giving a little gas it runs well. The problem has...

I would start by hooking up a vacume gage, if it reads low check for cracked or broken lines.

Nov 24, 2009 • 1997 Geo Metro

3helpful

1answer

When i start my 1997 Geo Metro, it often sputters

Try this
Here are the most common causes of surges, stalls at stops, low erratic idle speed, rough idle and engine hesitation, it is in most cases the idle speed control air-bypass valve and or throttle valve and upper intake, these area's get full of gunk and combustion residue over the miles and cause idle issues (stalls, low idle) like yours, Get a can of intake cleaner from any local parts store, not carb spray, intake cleaner, it is made by a company called CRC, remove the air intake hose to the engine, hold the idle high so the engine won't stall, then spray the can of cleaner into the intake while keeping the engine running, use at least 1/2 the can, shut down the engine and disconnect the battery for 5 minutes, then restart and complete a number of mixed driving cycles, town, freeway, stop and go etc., after a few days the problem will go away as the system will relearn to the clean intake.

Apr 03, 2009 • 1997 Geo Metro

0helpful

1answer

1996 Geo Metro 4 cylinder

http://www.fixya.com/cars/t591786-1997_geo_metro_starting_problem

look at this post, this may help, I am having the same problem and am going to try to find one of these parts.

Feb 24, 2009 • 1997 Geo Metro

Question 2

Anonymous

Master 3,092 Answers
Posted on Sep 16, 2010

Anonymous

Master

Joined: Nov 04, 2009

Answers

3092

Questions

1

Helped

1515512

Points

10827

Idle control, only controls idle, it will not cause no power, and that code could have set, due to no engine power, check fuel filter that it's not clog, could have good fuel pressure, but under load not getting enough gas, also check timing belt, if it jump a tooth, will cause no power, here's a figures so you can check timing belt. I have a 1997 Geo Metro 1.3L that starts but has - 3d3d9e0.gif

cheap repair Sep 18, 2010

a clogged cat converter will cause no power on acceleration. Hook up a vacuum tester to intake and start car. If vacuum slowly drops then your exhaust may be clogged up.

×

Related Topics:

Trustworthy Expert Solutions

I have a 1997 Geo Metro 1.3L that starts but has no power. Can not drive it. The code is P0505 idle control malfunction. I checked the fuel pressure and its ok. Whats next?

1 Answer

Anonymous

Add Your Answer

Attachments: Added items

Related Questions:

What is the code for P0505?

P0505 should be the IAC (Idle Air Control) System Malfunction

Code p0505

2002 honda civic code p0505

My 1997 geo metro 1.3liter keeps severly flooding with fuel no obd2 codes present

1997 Geo Metro with throttle body. Will start but no power, not enough to drive car. Will only slowly increase rpm's. After rpm's are higher, you can continually blip throttle and it runs normal...

Hello, I hsve a 1997 Geo metro 1.3L motor and it will start and run cold fine but after it warms up it starts running ruff and will even die on me. I have replaced the fuel pump, relay and fuel filter, I...

When engine gets hot, idle is up and down with the engine light on. OBD code gives a P0505 code.

My daughter has a 1997 geo metro LSI 4 cylinder, and the car will run fine then ususaly at idle it will start to run rough. By putting in nutrail and giving a little gas it runs well. The problem has...

When i start my 1997 Geo Metro, it often sputters

1996 Geo Metro 4 cylinder

Not finding what you are looking for?

1997 Metro

What is the code for P0505?

Ask a Question

Check Out the Latest Top Trucks Report!

Top Geo Experts

ZJ Limited

Thomas Perkins

Brad Brown

Are you a Geo Expert? Answer questions, earn points and help others

Manuals & User Guides

Related Topics:

Trustworthy Expert Solutions

I have a 1997 Geo Metro 1.3L that starts but has no power. Can not drive it. The code is P0505 idle control malfunction. I checked the fuel pressure and its ok. Whats next?

1 Answer

Anonymous

Add Your Answer

Attachments: Added items

Related Questions:

What is the code for P0505?

P0505 should be the IAC (Idle Air Control) System Malfunction

Code p0505

2002 honda civic code p0505

My 1997 geo metro 1.3liter keeps severly flooding with fuel no obd2 codes present

1997 Geo Metro with throttle body. Will start but no power, not enough to drive car. Will only slowly increase rpm's. After rpm's are higher, you can continually blip throttle and it runs normal...

Hello, I hsve a 1997 Geo metro 1.3L motor and it will start and run cold fine but after it warms up it starts running ruff and will even die on me. I have replaced the fuel pump, relay and fuel filter, I...

When engine gets hot, idle is up and down with the engine light on. OBD code gives a P0505 code.

My daughter has a 1997 geo metro LSI 4 cylinder, and the car will run fine then ususaly at idle it will start to run rough. By putting in nutrail and giving a little gas it runs well. The problem has...

When i start my 1997 Geo Metro, it often sputters

1996 Geo Metro 4 cylinder

Not finding what you are looking for?

1997 Metro

What is the code for P0505?

Related Topics

Ask a Question

Popular Questions

Geo Metro Turn signals not working. Replaced the

Geo metro timing diagram

How to change water pump in 1996 geo metro?

1994 Geo Metro Automatic Transmission

Gas or Oil shock & Struts

Check Out the Latest Top Trucks Report!

Top Geo Experts

ZJ Limited

Thomas Perkins

Brad Brown

Are you a Geo Expert? Answer questions, earn points and help others

Manuals & User Guides