Hi.i need help on my 2004 dodge caravan , its over 150000 miles and need to change Timing Chain or belt , but i am really don't know do its use Timing Chain or Belt ? what is timing Diagrams , please help me with TIMING DIAGRAMS pics thanks for your help.
This design has no tensioner. Check the sprockets for wear on the tips--especially the crank sprocket. With the cover off, turn the crankshaft with a socket and see how close the chain comes to slipping backward on the sprocket. There are complete replacement procedures at AutoZone.com, which I will try to paste in below.
3.3L and 3.8L Engines
See Figure 18
Fig. Fig. 18: Timing mark alignment-3.3L and 3.8L engines
If possible, position the engine so that the No. 1 piston is at TDC on the compression stroke. Disconnect the negative battery cable. Drain the coolant.
Remove the timing chain case cover. For more information, refer to the Front Timing Cover and Seal procedure, earlier in this section.
Remove the camshaft gear attaching cup washer and remove the timing chain with both gears attached. Remove the timing chain snubber.
To install:
Assemble the timing chain and gears.
Turn the crankshaft and camshaft to line up with the key way locations of the gears.
Slide both gears over their respective shafts and use a straight edge to confirm alignment.
Install the cup washer and camshaft bolt. Tighten the bolt to 35 ft. lbs. (47 Nm).
Check camshaft end-play. The specification with a new plate is 0.002-0.006 in. (0.051-0.052mm) and 0.002-0.010 in. (0.51-0.254mm) with a used plate. Replace the thrust plate if not within specifications.
Install the timing chain snubber.
Thoroughly clean and dry the gasket mating surfaces.
Install new O-rings to the block.
Remove the crankshaft oil seal from the cover. The seal must be removed from the cover when installing to ensure proper oil pump engagement.
Using a new gasket, install the chain case cover to the engine.
Make certain that the oil pump is engaged onto the crankshaft before proceeding, or severe engine damage will result. Install the attaching bolts and tighten to 20 ft. lbs. (27 Nm).
Use tool C-4992, or equivalent, to install the crankshaft oil seal. Install the crankshaft pulley using a 5.9 in. suitable bolt and thrust bearing and washer plate L-4524, or equivalent. Make sure the pulley bottoms out on the crankshaft seal diameter. Install the bolt and tighten to 40 ft. lbs. (54 Nm).
Install all other parts removed during the chain case cover removal procedure and fill the engine with oil.
Connect the negative battery cable, road test the vehicle and check for leaks.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
The 3.3 L Caravan engine does not use a timing belt.. It is timing chain set up. What belt are you talking about that broke?? The serpentine belt that drives all the accessories??
if this has a chain then you have forgotten about the chain tensioner and chain slippers,which is what keeps tension on the chain.if you mean timing belt then the same thing applies but only a belt tensioner that needs adjusting.make sure the routing is correct.
×