2 litre ford timing belt diagram 2000 escort zx2 (dohc) .is belt failure always catastrophic

Click on the following free direct Link. It has the Serpentine Belt Diagrams for your 2001 Ford Escort ZX2 2.0L DOHC In-Line 4-Cylinder Engine with Engine Options (AC/No AC etc.). Plus additional Instructional and Directional Diagrams.


http://www.2carpros.com/car_repair_information/year/2001/make/ford/model/zx2/2001_ford_zx2_drive_belt_routing_diagram.htm

Let me know if this helped, or if you have additional information or questions. Feel Free to contact me at FixYa.com!

Click on the following free direct Link. It has the correct Serpentine/Drive Belt Diagrams for your 1999 Ford Escort ZX2, 2.0L DOHC In-Line 4-Cylinder Engine.
The Link says 2000 for the Year, however this is the same as the 1999 Year Model.

http://www.2carpros.com/car_repair_information/year/2000/make/ford/model/zx2/2000_ford_zx2_drive_belt_routing_diagram.htm

Let me know if this helped, or if you have additional information questions. Feel Free to contact me at FixYa.com!

The tensioner is between the a/c compressor and crank pulley, below the power steering pump. Use a 13 mm wrench to 'tighten' the bolt in the center of the pulley and it'll move to release tension off the belt.

Click on the following free direct Link.
It has the correct Belt Diagram for your 2000 Ford Escort ZX2.

Let me know if this helped, or if you have additional information questions. Feel Free to contact me at FixYa.com!

http://www.2carpros.com/car_repair_information/year/2000/make/ford/model/zx2/2000_ford_zx2_drive_belt_routing_diagram.htm

All of Ford's belt driven engines are non-interference with the exception of the 3.0L villager which was really a nissan.

Try this link.

http://www.autozone.com/shopping/repairGuide.htm?pageId=0900c152801e9826

Hi!

Please check this out---


Please rate this solution and ask for any clarifications if needed.

Thanks
Rylee

Call a Ford parts dept and ask them if you can get a routing diagram they can fax or pick it up thats the best way label take weeks to get in so do that and keep the copy in your car file Please rate my response thank you very much

cam shaft timing marks on back of cams ,two slots ,use a flat piece of metal to align .remove no1 spark plug and drop long thin screwdriver down it to bring piston just below tdc,then align cams so both cams are on the rock (valves closed) with knob on back cam aligning with pick up sensor left side between lobes.then bring piston up to tdc and fit belt.turn engine over twice with socket on bottom pulley to make sure no valves clear pistons.Remember to remove flat edge from back of cams i didnt last time and bent my home made tool

2.0L Engines
See Figures 11, 12 and 13
The accessory drive belt for 2.0L engines has no provision for manual belt adjustment, since these engines use an automatic belt tensioner. Drive belt slack is taken up by the automatic tensioner.
Movement of the automatic tensioner assembly during engine operation is not a sign of a malfunctioning tensioner. This movement is the tensioner self-adjusting and is required to maintain constant belt tension.
The belt tensioner has a belt length indicator. If the indicator marks are not between the MIN and MAX marks, the belt must be replaced.
Fig. 11: Drive belt routing-2.0L SOHC engine with A/C Fig. 12: Drive belt routing-2.0L SOHC engine without A/C Fig. 13: Drive belt routing-2.0L DOHC engine