Error in sensor throttle sensor nissan tiida engine HR15 , leak power in aceleration , variation aceleration , need part for replace throttle sensor

You miss understand why things need to be torqued .
Torque is not specific to the vehicle its the bolt how hard what is thread pitch how many threads per in or mm how many bolts and what kind compression is required .
Compression always needs to be even say you have a cork gasket on an oil pan with 25 bolts 10 ft lbs on each would give you 250 ft lbs of force but if not done in stages evenly you would be snapping bolts and bending the pan and would leak oil from the start .
Spark plugs have seals 5/8 25 lb ft is fine but its not something you are going to get a torque wrench on .

Well my friend in need, that could be the T.P.S ,(Throttle positioning sensor; located on the Throttle body!! To find device easier. Have someone operate accelerator, while you observe.
The tps will move with the accelerator cable.
It could also be mass air flow sensor, located in the air intake ,somewhere!! Good luck!
.

tps is throttle position sensor. what is your question?

Maybe clutch plates and pressure plates make such noise

try to test the car with another pedal.... or check the socket that connects the throttle nd the brain box for partial contact,wire harness,...

the first thing to do is fix the sensors that are producing the lots of errors as reported by the code reader (laptop). When the units are replaced/repaired then run the fault codes again to see what hasn't been fixed Repeat the process until there are no codes left to read. If you have 2 fans in front of the radiator ensure that one fan is not for the ac unit and it will run on ignition if the ac is switched on. If it is a radiator fan then check the coolant temperature sensor switch and the relay for the fan.

Here is the definition. You may need to have someone check the accelerator pedal position sensor and the circuit.

P2138 NISSAN Description The Accelerator Pedal Position (APP) sensor is installed on the upper end of the accelerator pedal assembly. The sensor detects the accelerator position and sends a signal to the Engine Control Module (ECM).
Accelerator pedal position sensor has two sensors. These sensors are a kind of potentiometers which transform the accelerator pedal position into output voltage, and emit the voltage signal to the ECM.
In addition, these sensors detect the opening and closing speed of the accelerator pedal and feed the voltage signals to the ECM. The ECM judges the current opening angle of the accelerator pedal from these signals and controls the throttle control motor based on these signals.
Idle position of the accelerator pedal is determined by the ECM receiving the signal from the accelerator pedal position sensor. The ECM uses this signal for the engine operation
such as fuel cut.
Read more: http://engine-codes.com/p2138_nissan.html#ixzz26J3D2x8s

my sensor light stays on and the car idles very ruff, what can it be

Check that all sensors around throttle are connected.

CODE P1278- HEATED OXYGEN SENSOR 1 SLOW RESPONSE.POSSIBLE CAUSE EXHAUST LEAK AT EXHAUST MANIFOLD OR PIPES.FAULTY PRESSURE REGULATOR LEAKING OR FUEL INJECTORS LEAKING.AND FAULTY TPS SENSOR.