- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
I have found a short cut for changing the front turn signal bulb
Remove the inner fender well cover and then you can remove the light assemble from underneth and replace the bulb.
The cover is attached with a bunch of push on body clips, pry the button up with a screwdriver and pull out fastner.
Then there are two screws holding the light assembly on the bottom and inner side, it clips into the bumper on the outter side. From there it's pretty simple.
FYI the GE replacement cross reference is wrong it's a Sylvania 3757A LL bulb.
Nope don't need to drop the whole light assembly. I just took the wheel and inner cover off, then the 6 torx screws that hold the light hosing together , replaced the turn signal bulb and good to go!!
Front turn signal bulb replacement 2008 SRX . Jack up car & block . Remove front wheel & front half of the wheel house assemble. There are about 7 plastic pull rivets that have to be removed . Pull out the wheel house . Remove turn signal & driving light cover held on by 6 # T10 torx screws . Twist out socket & replace bulb # 3757NAK . Should take about 45 min.
There might be a way to sneak the bulb out, but most likely the bumper cover will have to be removed it is a stupid design that gives you no room to work.
Should be able to open the hood remove plastic headlight cover & pull pins (2) on light assembly whole light assembly will pull out then replace turn signal.
You must take the front wheel off, then remove the inner front fender panels (2), they are fastened with plastic pushbuttons. this exposses the light housings for the turn and fog lambs. This takes about an hour, but saves you alot of money.
In your manual on page 5-53 it states how to change the bulb out
for the turning signals - we had the drivers side out. Gave it to our mechanic and had it completed in about 2 hours.
×