1994 nissan sentra drivers door wont open from inside or out is it possible to pop door latch with screw driver or anything to get door open so i can remove the door panel and get a better look at things

Hi,

you might have to remove the portions on either side of the console before you remove the middle portion. Please open the glove compartment and look for any screws that you can unscrew with a screw driver and open up. This opening should give you more access to the side of the middle console and there should me more visibility into other screws, latches etc that be undone in order to remove the middle console. Otherwise, please work with a mobile mechanic to achieve this goal.

Thank you.

the latch rod has came off,you will have to remove the door panel to repair

take off inside door panel then interior handle then latch at end of door in the jamb it will come right out remove all screws that hold these items in no matter how many there are

If power windows and the same window does not open the child safety switch is a very good possible reason.

If it were me , I'd remove the inside door panel and take it from there. It may be that you can pry open the lock mechanism with a screw driver or a similar tool, allowing you to open the door - which obviously you must do. Even that, though, will not solve the cause of your problem. You may wind up at the dealer.

The latch is located close to the center of the hood, slightly on the driver's side. Push it up.

When you say door latch, what exactly are you referring to? There is the locking latch, inner and outer opening latch, or the door jam latch? Take the door panel off, make sure that the window is up, and then you will have access to any of the latches. The door jam lock/opening latch will have some screws in it, 3 total, you can take those out and off for better access to the actual door lock mechanisms.

BECOS YOU HAVE DIFFRENT ARM ROD FOR THE INSIDE AND THE OUT SIDE TAKE OFF THE PANEL AND YOU WILL SEE IT WHEN PULL THE INSIDE PANEL OFF ,PULL THE HANDLE AND YOU WILL SEE WHERE IT SUPPOSE TO BE AND JUST REPLACE IT

hold handle for door in open position w/ straight screw driver pop latch rod back out, use wd40 on both locks, hope i helped!!!

Open drivers door, locate plastic plug on inside of door, near latch, across from door lock cylinder. Pop it out. There is a set screw that retains lock cylinder. Tighten set screw.