Where to get window open/closing switches - 1998 Oldsmobile LSS

(a) Turn the engine switch on (IG).

(b) Halfway open the power window by pressing the power window switch.

(c) Fully pull up the switch until the power window is fully closed and continue to hold the switch for approx. 1 second after the power window is fully closed.

(d) Check that the AUTO UP/DOWN function operates normally.

If the AUTO UP/DOWN function operates normally, reset operations have been completed at this time. If not normal, follow the steps below.

(1) Disconnect the negative battery terminal for 10 seconds.

(2) Connect the battery terminal.

(3) Turn the engine switch on (IG).

(4) Halfway open the power window by pressing the power window switch.

(5) If the AUTO UP/DOWN function operates normally, reset operations have been completed at this time.

If not normal, follow the steps below.

(6) Turn the engine switch on (IG).

(7) Halfway open the power window by pressing the power window switch.

(8) Fully pull up the switch until the power window is fully closed and continue to hold the switch for approx. 12 seconds after the power window is fully closed.

(9) Check that the AUTO UP/DOWN function operates normally.

If the master switch will open and close the windows and the rear switches open them, won't close them, replace both rear switches.

Owner's Manual page 2-26 : http://www.vadengmpp.com/owners-manual/pontiac/2004-Pontiac-Montana.pdf

This switch, located in the overhead console switchbank, is used for opening and closing the power rear quarter windows. Press the textured part of the switch to open the windows; both windows will open. The windows will continue to open as long as the switch is pressed, until they are fully opened. Press the part of the switch with the symbol to close both windows. The windows can be closed fully or partially, depending on how long the switch is pressed.

pinched wire..

Hi! You may want to start spraying contact cleaners on the control switches. If these switches are seldomly used this issues happens. Try it and see how it goes. Hope this helps and thank you for using FixYa!

dis-connect your battery for 30 seconds to do a switch reset on your window, when you reconnect the batt your window will go down, open and close rear door to check lock functions ok first. close rear door and using key or switch inside car close window fully with out stopping, this should reset the window.

You have to reset the windows and sunroof after you change the battery. For windows open the driver half way and close the window up and hold the up switch for few seconds. If that don't work open the rear window from rear switch and that should work.
For moon roof open the moon roof and keep the hold the open button pressed for 10 seconds. Then close the moon roof and hold the close button pressed for 10 seconds

try here Bimmerforums The Ultimate BMW Forum

window motor