Where is the fuse block? - 2005 Chrysler Town & Country

Underhood Electrical Center or Junction Block Replacement

Removal Procedure

1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure in Engine Electrical.


Click to Enlarge

2. Disconnect the positive battery cables from the underhood fuse block terminals.
3. Remove the tape from the wiring harness at the base of the underhood fuse block base.


Click to Enlarge

4. Release the underhood fuse block(s) clip retainers using a small flat-bladed tool.


Click to Enlarge

5. Remove the fuse block(s) and wiring harness lifting up from the base and reposition from the base.


Click to Enlarge

6. Remove the nuts from the underhood fuse block base.
7. Remove the underhood fuse block base from the shock tower.


Click to Enlarge

8. Remove the underhood fuse block lower front terminal positive assurance retainers using a small flat-bladed tool.


Click to Enlarge

9. Remove the plastic shields from the battery cable and buss bar terminals, using a small flat-bladed tool to release the clip retainer.


Click to Enlarge

10. Remove the bolts from the buss bar jumper bar.


Click to Enlarge

11. Remove the buss bar jumper bar from the fuse block(s).


Click to Enlarge

12. Remove the fuses from the fuse block(s) to access the buss bar terminal release tabs.


Click to Enlarge

13. Remove the buss bar(s) from the fuse block(s) using a terminal releasing tool, and pulling down and out on the buss bar.


Click to Enlarge

14. Remove the buss bar(s) from the fuse block(s).


Click to Enlarge

15. Release the clip retainers from the underhood fuse block(s) battery cable and buss bar terminals using a small flat-bladed tool.


Click to Enlarge

16. Remove the underhood fuse block(s) battery cable and buss bar terminals from the fuse block by pulling down.
17. Remove the fuse block and lamp wiring harness from the vehicle, if required.

I copied the info from my database, sorry, it is read only, The way I copied it, read only, no pictures.

Fuse Block - I/P-instrument panel
Under the right side of the I/P, near the rear of the I/P compartment
Fuse Block - Rear
In the right rear of the passenger compartment, under the rear seat cushion
Fuse Block- Underhood- Left
In the right front of the engine compartment, near the battery
Fuse Block - Underhood - Right
In the right front of the engine compartment, near the underhood fuse block
Fuse Holder - Steering Column
On the left side of the passenger compartment, at the base of the steering column

Connector 1:
Fuse Block - Underhood Label (2.2L, 2.4L)
Connector 2:
Fuse Block - Underhood Top View (2.2L, 2.4L)
Connector 3:
Fuse Block - Underhood Bottom View (2.2L, 2.4L)
Connector 4:
Fuse Block - Underhood C1 (2.2L, 2.4L)
Connector 5:
Fuse Block - Underhood C2 (2.2L, 2.4L)
Connector 6:
Fuse Block - Underhood C3 (2.2L, 2.4L)
Connector 7:
Fuse Block - Underhood Label (2.0L)
Connector 8:
Fuse Block - Underhood Top View (2.0L)
Connector 9:
Fuse Block - Underhood Bottom View (2.0L)
Connector 10:
Fuse Block - Underhood C1 (2.0L)
Connector 11:
Fuse Block - Underhood C2 (2.0L)
Connector 12:
Fuse Block - Underhood C3 (2.0L)
Connector 13:
Body Control Module (BCM) Label
Connector 14:
Body Control Module (BCM) Top View
Connector 15:
Body Control Module (BCM) Bottom View
Connector 16:
Body Control Module (BCM) C1
Connector 17:
Body Control Module (BCM) C2
Connector 18:
Body Control Module (BCM) C3
Connector 19:
Body Control Module (BCM) C4
Connector 20:
Body Control Module (BCM) C5 (UE1)
Fuse Block - Underhood Label (2.2L, 2.4L)
2.2L

alt="Object Number: 1438995 Size: MF">

alt="Click here for detailed picture of above image.">

2.4L

alt="Object Number: 1583009 Size: MF">

alt="Click here for detailed picture of above image.">

Fuse Block - Underhood Label Usage (2.2L, 2.4L)
No.

Device

Rating

Description
1

ECM (2.4L)/TCM Fuse
10A

ECM (2.4L)/TCM
2-3

--
--

Not Used
4

RH HDLP Fuse
15A

Headlamp - Right
5

A/C Fuse
10A

A/C CLUTCH Relay
6-7

--
--

Not Used
8

ABS Fuse
10A

EBCM (JM4)
9

ECM/ETC Fuse
15A

ECM
10

EMISS Fuse
15A

EVAP Canister Purge Solenoid, Coolant Level Switch, MAF Sensor, HO2S 1, and HO2S 2
11
IGN Fuse
10A
ICM and PNP Switch (A/T)
12
--
--
Not Used
13
TRANS2 Fuse
10A
ECM, Automatic Transmission
14
TRANS1 Fuse
10A
TCM (MN5)
15
BACK UP Fuse
10A
PNP Switch (A/T) or Backup Lamp Switch (M/T)
16
INJECTORS Fuse
10A
Fuel Injectors 1-4
17
FOG LP Fuse
10A
FOG LAMP Relay (T37)
FOG LP Fuse
15A
FOG LAMP Relay (T96)
18
LH HDLP Fuse
15A
Headlamp - Left
19
WIPER Fuse
25A
WIPER 1 Relay
20
HORN Fuse
10A
HORN Relay
21
RADIO Fuse
20A
Audio Amplifier (UZ6)
22
ABS Fuse
20A
EBCM (JM4)
23
RR DEFOG Fuse
30A
REAR DEFOG Relay
24
A/C CLUTCH Relay
--
A/C Compressor Clutch

According to http://x3.xbimmers.com/forums/showthread.php?t=530507 kmarei says:
The X3 has (2) fuse blocks:

Fuse Block #1 is behind the glove box and is accessed through the removable panel at the far right at the back of the open glove box. The fuses are (5) or (6) inches behind the back of the glove box and will probably take someone with a very thin wrist or better yet, a surgical forceps or very long nose pliers to change. This fuse block houses fuses Nos. 1 through No. 67.

Fuse Block No. 2 is housed in the right rear fender. To access it you must remove the small right rear storage cover (pull firmly on the black hand hold). Then you must remove the plastic "push rivet" at the rear of the insulation cover. Pry the center pin out with a screwdriver or small knife, and then completely remove the plastic "rivet". Then simply roll the insulation cover forward and you will find the fuse block.
Fuse block No. 2 houses fuses Nos. 100 to No. 204.

The sheet listing the fuse locations for BOTH fuse blocks is folded and stored in a slot at the bottom of the fuse block (No. 2).


Or: Try watching this YouTube video: https://www.youtube.com/watch?v=-Ph-KB7LIu0 if I helped you, please let me know. :)

The power window system uses 2 fuses, one main 30A "Power" fuse which is a large block type fuse found on the outer side of the steering column behind the dash in a large junction block, set on this block away from the main fuse group. The second one is a 10A "Guage" fuse which is a smaller blade type fuse found in the same location on the same junction block, but in the cluster of blade fuses on that block.

There are two fuse boxes

1. Passenger compartment

The Passenger compartment fuse block access door

is on the driver's side edge

of the instrument panel. Pull

off the cover to access the

fuse block.

You can remove fuses with

a fuse extractor. The fuse

extractor is mounted to the
fuse block access door
2.Underhood Fuse and Relay center

The underhood fusehelay center is located in the rear of

the engine compartment near the brake fluid reservoir.

Move the retainer clips for the cover to access the

fuse block.

You can remove fuses with a fuse extractor. The fuse

extractor is mounted to the interior fuse block. To

remove fuses if you don't have a fuseex tractor, hold the

end of the fuse between your thumb and index finger
and pull straight out.

Hello: Instrument panel fuse block- located on the instrument panel (passenger side consel) near the
floor. Remove the panel then the fuse block cover. Engine compartment fuse block: Under the hood on driver side near the battery. You may have to remover cover to access the fuse block. Rear compartment fuse block Located in the trunk. Access the fuse through the trunk panel on the driver side. The inside of the fuse block covers give you the location, size of fuse and purpose. Hope this helps.

I read over the recalls and they do have recalls on brake and turn signal lights but not the low beam headlights while driving at night.

Sounds like the relay or headlamp driver module relay 46, for the headlights is going bad, though.
Or, it could alternatively be bad grounding of wire somewhere or bad wiring in general.

I would check in the underhood fuse box for the relay and see if wiggling it to ensure a good connection helps matters.


Underhood Fuse Block 4.2L Engine Except Saab Underhood Fuse Block (2002 - 2005 Early Production)

Underhood Fuse Block (2005 Late Production - 2007)

Saab Underhood Fuse Block (2005)

Underhood Fuse Block (2005 - 2007)

5.3L Engine Except Saab Underhood Fuse Block (2003 - 2005 Early Production)

Saab Underhood Fuse Block (2005)

Underhood Fuse Block (2006 - 2007)

5.3L & 6.0L Engines Except Saab Underhood Fuse Block (2005 Late Production - 2007)

What engine size? Underhood Fuse Block 4.2L Engine Except Saab Underhood Fuse Block (2002 - 2005 Early Production)

Underhood Fuse Block (2005 Late Production - 2007)

Saab Underhood Fuse Block (2005)

Underhood Fuse Block (2005 - 2007)

5.3L Engine Except Saab Underhood Fuse Block (2003 - 2005 Early Production)

Saab Underhood Fuse Block (2005)

Underhood Fuse Block (2006 - 2007)

5.3L & 6.0L Engines Except Saab Underhood Fuse Block (2005 Late Production - 2007)

The main fuse block is located in the underside of the instrument panel, in or behind the glove compartment. Remove the access cover in the glove compartment to access the fuse block. Spare fuses and a fuse puller should always be kept here. Various convenience connectors, which snap-lock into the fuse block, add to the serviceability of this unit.


On some vehicles, you may have to remove a cover for access to the main fuse block


The main fuse block is in or under the glove compartment