Question about 2006 Chevrolet HHR

1 Answer

2006 hhr has code for cam sensor/diff module? will this make tc light and engine come on also rough shifting.....where is this located on vehicle?

Posted by ray_raftery on


1 Answer


  • Level 1:

    An expert who has achieved level 1.

    New Friend:

    An expert that has 1 follower.


    An expert that hasĀ over 10 points.


    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 2 Answers

Stand in fromnt of the car, the cam shaft position module is located on the front of the engine to the right hand side just below the fuel rail.

Posted on Aug 08, 2010

  • 1 more comment 
  • Anonymous Aug 08, 2010

    I'm having the same issue with the tc system and cam position sensor issue with my '06 hhr. the tc light comes on at 55mph, then shortly after, the engine light. I'm thinking its a traction sensor problem.

  • Anonymous Aug 08, 2010

    here is a diagram showing the location.

  • prismamartin
    prismamartin Apr 20, 2012

    Hi I have a 2006 Chevy HHR it has about 63,000 miles I've always maintanied it with Oil Change when it's needed but recently it's been showing the Check Engine and than a few miles later will show the TC and will make the car shake for a minute how can I fix it?



Add Your Answer


Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

P0010 code

Hi Roger,here's a link on your codes.

Mar 18, 2013 | 2006 Chevrolet HHR

2 Answers

Traction control on chevy hhr 2006

The traction control and transmission shifting would involve the body computer more so than the engine computer.
Have you had the body computer scanned for trouble codes ?

Sep 03, 2012 | 2006 Chevrolet HHR

1 Answer

P0068 on a 2006 Dodge Ram 1500 SLT. Rough "hunting" for idle. Momentary lag/loss of power from a stop. Random RPM changes while at a constant speed. Sometimes it feels like it drops out of gear...

P0068 Symptoms - Engine Light ON (or Service Engine Soon Warning Light)
- Lack/Loss of power
- Engine rough idle Possible causes - Large vacuum leak
- Leaking air duct system
- Mass Air Flow (MAF) poor electrcial connection
- Manifold Absolute Pressure (MAP) poor electrcial connection
- Faulty Mass Air Flow (MAF) sensor
- Faulty Manifold Absolute Pressure (MAP) sensor
- TP sensor not seated properly.
- Faulty Throttle Position (TP) sensor.
- Dirty throttle body
When is the code detected? The Powertrain Control Module (PCM) monitors operation rationality check by comparing sensed throttle position to mass air flow readings
P0068 DODGE Description The Powertrain Control Module (PCM) monitors a vehicle operation rationality check by comparing Throttle Position (TP) to Mass Air Flow (MAF) readings. If, during a self-test, the comparison of the TP sensor and MAF sensor readings are not consistent with the calibrated load values, the test fails and a diagnostic trouble code is stored in continuous memory.

Jul 10, 2011 | Dodge Ram 1500 Cars & Trucks

2 Answers

Where is the power stiring fluid located at

Hello, this vehicle doesnt have a hydralic power steering fluid system. this vehicle uses a electric power steering system. if you are having power steering issues with this veicle, you will need to have the electronic steering system scanned for trouble codes

Dec 09, 2010 | 2006 Chevrolet HHR

2 Answers

2006 HHR, check engine light came on, the engine coolant temperature gauge stays at 0 and the coolant link on my panel just shows ----F. Also my remote start won't work

Your coolant temp sensor is not registering. It probably set a trouble code, that's why your remote vehicle start is not working. The temp sensor is located at the rear corner of the engine block on the back side of the engine. This will be the corner of the engine closest to the driver. The temp sensor may be faulty, unlugged or there could be problem in the circuit. Even if you find the sensor unplugged and you plug it in, the code will have to be cleared before the remote vehicle start works again.

Oct 03, 2009 | 2006 Chevrolet HHR

1 Answer

I have a 2006 hhr and the abs and tc light is on and stays on? I had left the gas cap off and ever since the engine light and that is off and now this?

Could be a problem with the wheel hub. Had the same problem on a Grand Am. Don't know about the HHR. I had to replace the hub. The vibration from the bad hub causes the ABS sensor to trip. When the ABS light is on, it turns the T/C off.

Apr 15, 2009 | 2006 Chevrolet HHR

3 Answers

2006 Chevrolet HHR LT Problem

After searching around, I found several posts that suggested reseating all the relays and fuses under the hood. After checking, I noticed nearly all of them were not seated well. I pushed them all down and I haven't had the problem since.


Sep 20, 2008 | 2006 Chevrolet HHR

Not finding what you are looking for?
2006 Chevrolet HHR Logo

1,055 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts


Level 3 Expert

85239 Answers

john h

Level 3 Expert

23590 Answers

Joe Taylor
Joe Taylor

Level 3 Expert

2228 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides