-
Ford Master
6,826 Answers
- Posted on Jul 06, 2010
Re: How to replace rear breaks on 2005 f350 super duty...
Rear
To Remove:
- Remove the brake master cylinder filler cap and remove fluid until the reservoir is half full.
- Raise and safely support the vehicle.
- Remove the rear wheel and tire assembly.
CAUTION
Never allow the brake caliper to hang from the brake hose.
- Remove the two disc brake caliper pin bolts.
- Lift the disc brake caliper from the anchor plate and position the caliper out of the way. Do not disconnect the fluid line.
- Inspect the disc brake caliper for leaks and replace the caliper if necessary.
- Remove the pads and retraction clips.
To Install:
CAUTION
Do not allow grease, oil, brake fluid or other contaminants to contact the pad lining material.
- Install retraction clips.
- Install the brake pads.
- Slowly compress the caliper pistons with a large C-clamp.
CAUTION
Use care not to damage the bleeder screw or front disc brake rotor shield.
- Install the disc brake caliper.
- Install the disc brake caliper pin bolts. Tighten the pin bolts to 26 ft. lbs. (35 Nm) (F-250, F-350 SRW). Tighten the pin bolts to 56 ft. lbs. (76 Nm) (F-350 DRW). Tighten the pin bolts to 46 ft. lbs. (62 Nm) (F-450 F-550).
- Install the wheel and tire assembly.
- Lower the vehicle.
- Fill the brake master cylinder reservoir with DOT 3 motor vehicle brake fluid.
- Inspect for correct brake operation.
×