Question about 2007 Volkswagen Rabbit

1 Answer

Lift point for front tire - 2007 Volkswagen Rabbit

Posted by cindy_huntin on

Ad

1 Answer

geoff hunter

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 4,793 Answers

"lift point for front tire" what the hell is that.....?

Posted on Jun 24, 2010

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do I remove the flat tire


Hi Frank:
- Block the diagonally opposite tire.
- Set the parking brake
- Put the transmission in Park or Low gear.
- Set the jack under the frame or body lift point.
- Jack up until tight against lift point
- Remove trim cover if present
- Use wheel nut wrench to loosen nuts. Do not remove nuts.
- Jack up until wheel off ground.
- Remove wheel nuts.
- Wheel should now be able to be removed. Sometimes they will need a kick to loosen them. If still stuck, reply as a COMMENT to this e-mail and I'll give you some other hints.
If you want to remove the tire from the rim, click on this youtube link.
https://www.google.ca/#q=youtube+remove+tire+from+rim
Cheers.

Jan 21, 2016 | Cars & Trucks

1 Answer

Tires point outward after leveling kit install


It is an alignment problem caused by you raising the vehicle 2" Have the toe in adjusted to positive and have the camber reset to positive as well. As you raise the vehicle you shorten the tie rod end making the tyres point out and the tyres will also lean more out at the top causing the tyres to scrub on the outsides. Unfortunately because you have run the tyres in this condition they will continue to wear in the same pattern after an alignment so you will be up for 2 new tyres. to fix the problem properly

Jul 21, 2013 | 2011 Nissan Titan Crew

1 Answer

I have a 93 rodeo 3in suspension lift 3 in body lift on 38 tires what gears for front and back is best it is v6 4x4


front and back have to match start with 4;11 or 4:56 that should put you close to the right rpm range with that tall of a tire.

Feb 28, 2012 | 1993 Isuzu Rodeo

1 Answer

Where are the chrysler pacifica 2006 lift points for lifting it up onto a hoist.


VECHICLE LIFT POINTS IS WHERE FACTORY TIRE JACK GOES. WHERE YOU SEE NOTCHES IN FRONT AND REAR ROCKER PANEL.THATS THE LIFTING POINTS TO KEEP CAR CENTER GRAVITY.IF NOT SURE GO TO A GARAGE THAT HAS LIFT.ASK A MECHANIC OR TIRE SHOP THAT HAS A LIFT. THERE A DRIVE ON LIFTS AND DOUBLE POST COLUMN LIFTS YOU HAVE TO USE FRONT SUSPENSION AND THE REAR AXLE HOUSING TO SUPPORT VECHICLE.FOR SAFETY SAKE CHECK AROUND FIRST DONT GUESS I HEARD OF A MECHANIC LIFT CADILLAC ON COLUMN LIFT. DID NOT HAVE VECHICLE TO CENTER OF GRAVITY.CADILLAC FELL OFF LIFT CRUSHED HIM. SO IF YOU DO HAVE A COLUMN LIFT FIRST TIME USING IT LET GARAGE DO IT.YOU EITHER DAMAGE VECHICLE OR GET FATALLY HURT.

Nov 14, 2010 | 2006 Chrysler Pacifica

1 Answer

Where are the lift points for 2002 gmc envoy?


The lift points for a fllor jack are under the lower control arms in the front.The lift point in the rear are under the shock mounts on the axle.If you are using a hoist then the lifts points are the four corners on the lower part of the frame between the front doors and tires and rear doors and tires.I hope I could help, Rate me acordingly.Thanks...

Oct 11, 2010 | 2002 GMC Envoy

1 Answer

Jack placement on a 2002 chrysler 300m to fix a flat tire


Typically on Chrysler the lift point for the front tires is located just behind the wheel and for the rear just in front of the wheel. When you remove the cover that is over the spare tire there should be a diagram showing these. The User Manual will also designate these. These all assume you are using the original issued jack.

Jul 11, 2010 | 2002 Chrysler 300M

1 Answer

I need to lift up my 1993 eagle vision to change the front tires but don't know where to place the jack. my bottom is rusting so i want to be sure i'm on the frame


Look in your Owners Manual for the Recommended Jacking Points for your vehicle, Each vehicle is different so (one point specific point for all vehicles) does not always apply.

Jun 19, 2010 | 1993 Eagle Vision

1 Answer

LOOKING FOR THE BEST WAY TO LIFT A 2007 FORD RANGER FX4 ROUGHLY A 2" LIFT FRONT AND REAR.


Go for a supension lift. Rancho and skyjacker are two of my favorites. A body lift will allow for bigger tires but you can run into shift linkage problems. With a suspesion lift you get the bigger tires without having to modify little else

Feb 06, 2010 | 2007 Ford Ranger FX4 Off-Road

1 Answer

Where are the lift points to change the oil


Dear Lift Point Locater......Porsche's lift points are located on the sides of the vehicle where the pinch welds are.....kinda hard to spot by the untrained eyeball.....however......I have a much better idea for you.Rather than risking the potential damage to the side of the vehicle if you don't grab the pinch weld just right........invest in a set of durable plastic ramps from you local autoparts store or wal-mart...you can expect to pay a very small bill of $25-$35 for a set of nice ramps. And I would be much more comfortable with you crawlin under there to change your petroleum. You will have plenty of room to get under there and also you will have the vehicle up in the air quicker and easier......simply place them in front of your tires and drive up on them...clearance should not be an issue if the car is at stock ride height...Thx for you time... I HOPE I COULD HELP!!!

Nov 16, 2009 | 2006 Porsche Boxster

2 Answers

How do i check the ball joints 99 xplorer 4x4


Hello;
To check ball joints is relatively easy. There is a load carrying ball joint and a pivot ball joint. The pivot joint gets minimal wear. To check the load ball joint, jack up the wheel to be checked. With about an 1" of clearance off the ground, place your hand on top of the tire and wityh a long sturdy bar under the tire, move the bar up and down. Feel for lateral movement at the wheel. you want to make sure that the wheel bearings are good and the movement is slight if any.
Rich
RPM Northwest

Apr 13, 2009 | 1999 Ford Explorer

Not finding what you are looking for?
2007 Volkswagen Rabbit Logo

Related Topics:

44 people viewed this question

Ask a Question

Usually answered in minutes!

Top Volkswagen Experts

Marvin
Marvin

Level 3 Expert

85239 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14866 Answers

Mike

Level 3 Expert

4372 Answers

Are you a Volkswagen Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...