Question about 2005 Honda Element

1 Answer

When I started the ignition, it wasn't turn on, the battery is new, but my car doesn't started.

Posted by rcaraballo on

Ad

1 Answer

Anonymous

  • Level 1:

    An expert who has achieved level 1.

    MVP:

    An expert that got 5 achievements.

    Champion:

    An expert who has answered 200 questions.

    Governor:

    An expert whose answer got voted for 20 times.

  • Contributor
  • 435 Answers

Check the fuses

Posted on Jun 04, 2010

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Honda Accord keeps blowing fuse and won't start


Recently we had to put a new fuse in the starter ???????????? What fuse ? location , size . A fuse blowing means a electrical short to ground .

May 29, 2017 | 1998 Honda Accord

1 Answer

99 Jetta won't turn off when I remove the ignition key and the temperatur guage doesn't move but the fans come on?


Electrician has miswired the car or didn't properly repair the short. Very hard to know what he did wrong. Will he not fix it himself?

Aug 29, 2017 | 2000 Volkswagen Jetta TDI

1 Answer

Car doesn't start. when ignition is turned (new ignition) I hear a relay chatter and my horn sounds intermittely, Battery is new & tested goo


The chatter is due to low voltage. Check all the connections. The battery may have corrosion that lowers the voltage.

Oct 20, 2012 | 1999 Dodge Neon

1 Answer

I lost my key to my 1996 firebird. so i had the ignition changed out. at the same time my battery went dead. i put a new battery in and the car wont start all lights come on just wont turn on. the...


Your ignition takes a specific key, they are chipped. If the ignition was changed and the decoder wasn't , this is the problem. You may be able to call a dealer ship and give the VIN number and get the measurement in ohms of the chip, Maybe. Then go to a hard ware store and they can duplicate the key you have with a chip key. Be prepared , this is not a $2.00 key

Sep 02, 2011 | 2003 Pontiac Grand Am

2 Answers

1995 Toyota t100 3.4 Sr5 will crank but not start. Before the truck would not do anything in regards to starting . I changed the crank shaft sensor that didn't do it . I changed the starter that...


if this vehicle is an automatic an easy way to check if it is the safety switch is try starting the vehicle in neutral instead of park. it may save you a few bucks.

Aug 18, 2011 | 1995 Toyota T100 Xtracab

1 Answer

My 1999 mitsubishi diamante will not start. I got a friend to jump it but it still would not start. I took the battery out and took it to autozone to charge it. But autozone would not charge it because...


It sounds like you need a new starter. If you hear the starter click when you turn the key to start, replace your starter since you already replaced the battery. You might want to have your alternator checked out, or when you get your car started, test the battery terminals with a multimeter. You should have around 14 volts with the car running. If not, you will need a new alternator. The alternator won't keep the car from starting though, unless the battery was drained because it wasn't charged. Even then it is the battery keeping the car from starting.

If the starter is not clicking, check your fuses under the hood. If all checks out, you may have a bad ignition switch.

I’m happy to help further over the phone at https://www.6ya.com/expert/jeremy_69f3cc28d95bf514

Jul 02, 2011 | 1999 Mitsubishi Diamante

1 Answer

93" k1500 suburban- ignition key


I just saw your newer post..or the original post with more information available.

Your K1500 has the ignition switch positioned on the steering column. The switch is control via a linkage rod that is actuated from the key cylinder.(which may have failed.) But I suspect your problems may be in the switch itself.

See the procedure here at Just Answer Chevy to remove and install a new switch:
Fix Your Chevy With Your Own Hand

PS: After removing the actuator rod see if the lock cylinder rotates freely...if it does the switch is the source of your problem.

Aug 13, 2017 | 1993 Chevrolet K1500

1 Answer

Since last November, I noticed sluggish cranking on start. Sometimes the engine refuses to start much like a dead battery but the battery tests strong. I thought perhaps the new Interstate battery may...


Check the connections on the starter, and on the battery cables from the Honda. I know it sounds funny but I had the same problem with my BMW. It turned out there was corrosion on the the cables and it wasn't getting all the juice. Corrosion and or loose connections to the starter could be your problem...Hope this helps.

May 04, 2011 | 2003 Honda CR-V

Not finding what you are looking for?
2005 Honda Element Logo

Related Topics:

37 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

Marvin
Marvin

Level 3 Expert

85239 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8984 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...