Brake fluid how to put in

how much brake fluid did you remove or put brake shoes on wrong reason abs light on.check brake fluid.when replace front brakes you have make sure mastercylinder reservoir corver on then pump brake pedal seat brake shoes against rotor then check brake fluid level.

Do not start it brake fluid in the power steering. Will destroy the seal in the whole unit if you have started it you will need to take the return line off at the pump and flush it asap you can use trans fluid it has cleaner in it

Check your brake fluid level. Low fluid levels will cause the brake light to come on. If the fluid is not low, there could be a problem with the emergency brake light switch or the brake fluid level sensor.

Sounds like the wrong fluid has been put into the brake master cylinder.if so,the seals in the master cylinder will need replacement and the whole system looking at and bleeding.Quite often ATF (automatic transmission fluid) gets put into brake systems by accident and this is always the result.You would need to flush the whole system out to get rid of the fluid.

I'm not 100% sure on that car but every car I have worked on the brake fluid goes into the reservoir located in front of the master cylinder with is attached to the brake booster. Usually on the drivers side by the closer to the fire wall.

YOU NEED TO REMOVE 2/3 BRAKE FLUID FROM THE BRAKE FLUID RESERVOIR.YOU WILL NEED A LARGE C- CLAMP TO BOTTOM THE PISTON INTO THE CALIPER BORE USING A OLD BRAKE PAD OR WOODEN BLOCK ACROSS THE FACE OF THE PISTON.DONT DAMAGE THE PISTON OR THE CALIPER BOOT.WARNING WHEN FINISHING PUTTING ON NEW FRONT BRAKE SHOES.PUT COVER ON BRAKE FLUID RESERVOIR MAKE SURE BRAKE FLUID NOT LOW.PUMP THE BRAKE PEDAL UNTIL BRAKES FEEL FIRM THEN CHECK BRAKE FLUID LEVEL AGAIN ADD MORE FLUID IF NEEDED UNTIL LEVEL CORRECT.YOU ARE DONE. MAKE SURE YOU HAVE SOLID FIRM BRAKES BEFORE DRIVING.YOU WILL NEED THREADLOCKER GM P/N 12345493 ON THE CALIPER BOLTS OR EQUIVALENT THE AUTO PARTS STORE WILL HAVE THREADLOCKER.

put some more brake fluid in the master cyl you can buy a small container at any garage very cheap

pump brakes up and hold. have someone fill up resovouir. put top on and release brakes.

Brake fluid is the same fluid you put in the clutch master cylinder. Any mechanic will verify this.

on the driver side under hood there will be a small yellow cap on top of a reservior just in front the driver area. just open cap and install brake fluid until full.