How to make at 0 the maintenance conter for mercedes C200 CDI (1999)\r\n Best regards

If you need a code for your Mercedes Benz C200 1999 radio WDB2021201A274688, you will need to contact your local Mercedes Benz dealership. They will be able to provide you with the code that you need to access the vehicle's radio.

Go to any Pep Boys and get a Hanes manual for your vehicle.I personally have not heard of your situation.Didn't even know there was a separation in the fuel tank on your car.

readjust the sensor switch for the position of the boot or lock or replace it.

Your listing shows a 2000 Pontiac Montana...your question relates to the Mercedes? On the Pontiac, there are only 2 wire connectors to the engine starter motor...They use different sizes to match the connecting wires...

Hi
It sounds to me like it could be a glow plug fault !
The glow plugs heat the diesel before it combusts. An easy way to diagnose this is check your exhaust after cranking on a cold morning if you have thick white smoke then you've probably got a glow plug down on 1 of your cylinders or maybe more
Hope this helps Nick

when it shuts off at a half tank are you sure that the fuel tank has a half a tank and the sending unit is bad

could have restricted air filter or exhaust system has restriction, your turbo charger failing.

Hi Sayid, If you are not using it the container must be leaking. The most common causes are a broken pipe, a defective seal on the washer motor mount or the container is damaged and leaking. Regards John

Switch ignition on
Press trip counter button twice
Switch ignition off
Press and hold trip button while switching ignition on
After 10 seconds new service interval will be displayed +beep
Release trip button
Switch ignition off

hello,delayed acceleration,maybe coming from your transmission if you have auto. trans, you can try with other dealer maybe they have a trans. gauge to read the pressure of your trans,adjust if nec.better to have a record on maintenance,oil,fuel filter,trans.filter and brake fluid change if necessary or your control cable from engine to trans.maybe need to adjust,ty