1994 buick lesabre limited connecting rods torque and head torque

already answered here, 26 or 29 :>D

What are the torque specs for crankshaft main and rod - Fixya

https://www.fixya.com > ... > Buick > LeSabre
Sept 21, 2012 - The connecting rods torque to 29 foot pounds. ... Where is the eng control module in a 2005 Buick Rendezvous ultra 3.6 eng.
SOLVED: I need torque specs. for rod bearings and main - Fixya
Jun 2, 2011
Torque specs for intake on 2005 buick rendezsous - Fixya
Sept 7, 2019
Torque spec for1997 3.8 buick rod and mains - Fixya
May 22, 2012
What is the torque specks for a 3.8 lt v 6 rear main cap 1987 buick ...
Nov 14, 2019
More results from www.fixya.com

More here

https://www.google.com/search?q=05+Buick+Rendezvous+Ultra+3.6+piston+rod+torque
..

if a 17 mm bolt head then around 90 lbs if 19mm then 120lbs

It is part of the range selector switch on the transmission.
Get a wiring diagram if the trans wiring and it is very to follow to determine if it is working or not

check to see if you have any leaks in system. if not replace thermostat and go from there. good-day!

Torque sequence for what?What do you want to torque down.Intake,cylinder heads,valve covers,throttle body?You need to be more specific.

3.8L V6

cylinder head bolt torque

step 1 37 ft lbs.

step 2 an additional 130 degrees

step 3 4 center bolts an additional 30 degrees

Well the torque for the three retaining bolts should be about 75-85 ft lbs.and the hub nut about 100 ft lbs.

Hello insebard: My name is Roger and I will help. The connecting rods torque to 20 lb.ft. plus50 degrees. The rods torque in 3 steps they are. Step one. 35 lb.ft. Step two tighten an additional 130 degrees. Step three. tighten the 4 center bolts an additional 30 degrees. Should you need further help please just ask. Please rate the answer. This way I know it was helpful. Thank You for using Fix Ya. Roger

It is normal for the fan to run a couple of minutes after the engine stops running. If it still runs it could be a bad thermostatic switch.

Yes, you need to get a book to get you bearing oil clearances and torque specs.