At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.
What bolts need to be removed to take off front rotors of a 1999 Volvo s80? I have removed the pads but I am not sure which bolts to loosen or remove to get the rotor off.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
front ones remove wire clip remove bolts from caliper hang caliper out of way remove pads remove 2 bolts from pad carrier put to one side remove 2 disc retaining bolts remove disc may need hammer clean hub flange with wire brush fit new disc clean pad carrier and refit fit new pads put some copper grease on back of pads push in caliper piston slowly using large grips or g clamp fit and secure caliper pump up brake pedal check brake fluid level do other side for rear brakes see my solutions
when your remove the timing belt cover off the front of the engine the plastic part that stays bolted to the top of the engine has one slot over each cam between the 12 O'Clock and One O'clock position . hope this helps I could send a pic but it would be tomorrow
if this helps.. I had the 1998 model S70. the water pump was driven by the timing belt. you had to take the timing belt off just to replace the water pump. it was just a simple bolt on replacement. the only difficult issue is resetting the hydraulic tensioner on the timing belt. the hydraulic tensioner has to be completely taken off and compressed VERY SLOWLY in a vise. then insert a very hard drill bit or (special volvo tool) into a keeper hole, reinstall hydraulic tensioner onto car and reinstall timing belt.very quickly remove drill bit from keeper hole in tensioner and the tensioner snaps back out to put tension on belt. and you are done.
×