Why would the turn signals stop working. All

Bad flasher relay or blown fuse. Does hazards work if not and fuse is good than flasher relay is bad

Check the HZDLFL fuse# 40 - 15amp in the console fuse block
Fuse Block - Center Console
Inside of console, behind the right console access panel , if the fuse is good the turn signal / hazard flasher module is bad.
Turn Signal/Multifunction Flasher Module
In the fuse block - center console

Hi, you need to test if the power is coming to the plug for rear brake light. If the power is not there that is your first problems. Also may have earth wire problem.

First check the fuse for the signal lights to see if its blown.If the fuse is good then and look for a signal light relay and they is one then replace it with another one in the fuse panel that has the same part number on it to see if the signals will start working.If the fuse and relay are good then you will need to replace the signal switch.

WITH A GOOD FUSE TESTER, TEST ALL THE FUSES FUSEBOX UNDER THE HOOD & INSIDE THE VEHICLE. IF THE FUSES ARE ALL GOOD WITH THE TESTER YOU MUST HAVE A BAD BRAKE LIGHT SWITCH OR A BAD TURN SIGNAL SWITCH. THE BRAKE LIGHT CIRCUIT GOES UP THROUGH THE TURN SIGNAL SWITCH & THEN TO THE BRAKE LIGHTS. FIRST OF ALL IS THE BRAKE LIGHT SWITCH GOOD ? THE ORANGE WIRE FEEDS THE BRAKE LIGHT SWITCH, THE WHITE WIRE PUTS POWER TO THE TURN SIGNAL SWITCH, SO THE LIGHTS CAN BE USED AS TURN LIGHTS OR BRAKE LIGHTS. , PUT A TESTER IN THE WHITE WIRE & PRESS ON THE BRAKE PEDAL. IF THE TEST LIGHT LIGHTS UP, BRAKE LIGHT SWITCH IS GOOD, BY THE WAY THE BRAKE LIGHT FUSE MAY BE LABELED" STOP", THE FUSE LABELED" BRAKE" IS FOR THE ABS SYSTEM. TO CHECK THE TURN SIGNAL SWITCH FOR BRAKE LIGHTS, REMOVE THE PLASTIC COVER FROM UNDER THE STEERING WHEEL, PRESS ON THE BRAKE PEDAL, PUT THE TESTER IN THE SMALL YELLOW WIRE, THEN THE SMALL GREEN WIRE. IF THERE IS NO POWER IN EITHER WIRE, THE TURN SIGNAL SWITCH IS BAD.

did u check fuses under the hood on driver side lol yes ford has them thear also

it could be something as simple as a turn signal flasher

The signal lights work through a relay but the brake lights work through the signal switch, if both are out I think you'll find the problem is the signal switch.

the multifunction switch (turn signal switch) is a major cuase of this. your high mount stop lamp wire is run through the switch.