How do you reset the oil cgange indictor on a 2006 lincoln towncar

Yes they are the same generation stared with the 2003 up

Check your air intake sensor or 02 bank 1and 2 sensors

Follow the procedure found here

https://resetoillight.com/lincoln/oil-change-light-reset-lincoln-town-car-2006-2007-2008-2009/

The fuel pump reset button is commonly located in the passenger compartment behind a panel near the foot boards...passenger side and looks like a relay. The red button may be protruding and simply needs to be pushed back.

faulty sender unit in tank or wire has falen off the sender unit or its just stuck try tapping the tank if you can get at it vauxhalls are notorious for sticking

Try this... in order to reset CHANGE OIL SOON/OIL CHANGE REQUIRED message on the Message Center, press the STATUS control to access the System Check mode. Press the RESET button to display OIL LIFE _% RESET FOR NEW. Press and hold the RESET button until OIL LIFE IS 100% is displayed.

Hope this helps; also keep in mind that your feedback is important and I`ll appreciate your time and consideration if you leave some testimonial comment about this answer.

Thank you for using FixYa, have a nice day.

open your hood locate the back of the light that you want to replace these are usually held in place by self locks turn the light counterclockwise until it unlocks pull it out of the opening be sure that you dont touch the tip of the new bulb with your finger or hand or youll blow it as soon as you turn it on (the oils in your skin) put the new one in and reverse the process to install.

FIRST press and release the setup button to display oil life= xxx
then press and hold the reset button for about 2 sec it should then display oil life set to 100%
--------------------------------
Just pressing the reset button when the change oil light comes on while driving will not reset the computer

ok start by looking in the trunk for the fuel reset button it is on the right side , the black smoke is your exhaust valve seals . go to your parts house and get some lucas oil addidive it will work for a bandade

ask the dealership (parts department) for a drawing of the headlamp assemble. it might show all the mounting screws, good luck