Where is the location for the fuse for the parking lights2002 eclass

ALL PARK LAMPS DEAD 4 SIDES OF CAR????????
SERVICE MUNUAL COVERS ALL THAT 10X MORE ACCURATELY TOO.
THOSE LAMPS ARE PARK LAMPS
UP T0 12 PARKING LAMPS FRONT AND REAR
SURE SOME CALL REAR PARKS TAIL SURE
BUT IS ALL RUNNING OFF PARK FEED.
WHAT I DO IS CHECK ALL FUSES AND IS WAY FASTER THAN FINDING ANY SERVICE MANUAL
MY 2004 GV, i HAVE THE MANUAL FOR MINE NOW SOLD.
Okay READING YOUR MANUAL NOW ON LINE
FUSE 10 BLOWS THEY ALL GO DEAD NOT JUST ONE EVER. (FUSE CAUSED)
the held lamp relay #2 is parks.
relay2 runs inside illumination too and F10 blows kills al that.

f10 blown kill like 20 plus lamps out and inside car dead
it is marked TAIL but is wrong, it is parks and interior all. 1920 TAIL was tail. only
not now.

Try this image link for the right fuse diagram:

2000 Buick Park Avenue Where is the brake light fuses located Google Search

This link may help as well:

2000 buick park avenue brake light switch

What year is it ? Parking light or Parking LIGHTS

It's probably the park lamp relay in the rear fuse box , contacts stuck together ! The body control module turns on the relay after receiving a input from the headlamp switch !
The rear fuse box is located beneath the left rear seat !
30
PARK LP Relay
--
F PARK Fuse, LR PARK Fuse, RR PARK Fuse, TR PARK Fuse

Check the corresponding fuse

Usually the switch is bad on this year and model. Be sure to check fuse first of all.

Start up is in the starter/solenoid relay area.
Not moving in Drive could be trans fluid is too low, it has to be checked when warm(15 mins run) but as long as its well up the stick, cold, it should go. Has it got any safety switch to stop drive if park brake is on?

okay the dealer may be right,the wiring sometimes breaks from opening and closing trunk,the trunk release operates on the same power as door locks, if door locks work its not a fuse,check the wiring harness in the trunk near hinge, this system is a complex one,so if you dont see a broken wire in the harness,(you will have to untape the wiring to see every wire) have a tech check the system.

Go to link below and go down about 3 post there is a pic. of the fuse box locations.

http://www.mbworld.org/forums/c-class-w203/227982-fuse-box-map.html


Good Luck

if you have fixed the problem there is two ways to reset the light the easiest way is with a code reader any auto parts store will usually read codes for free and will usually erase them as well if you dont have a reader. the second way is to remove the negative battery cable for about 30 minutes to reboot the ecu. if you have not fixed what turned the light on in the first place it will come back on though

the fuse box is generally located between the drivers door and the dash board just check all the fuses until you find a blown one