1993 Mazda MX-6 Logo
Posted on Apr 25, 2010

93 mazda mx-6 fuel filter replacement?

I found out that the problem with my mazda mx-6 ls is the fuel filter i took the cruise control off and got to the fuel filter but i cant't get the two bolts to losen the housing it sits in because of the limited space

2 Answers

Anonymous

Level 1:

An expert who has achieved level 1.

MVP:

An expert that got 5 achievements.

New Friend:

An expert that has 1 follower.

Hot-Shot:

An expert who has answered 20 questions.

  • Contributor 24 Answers
  • Posted on Apr 25, 2010
Anonymous
Contributor
Level 1:

An expert who has achieved level 1.

MVP:

An expert that got 5 achievements.

New Friend:

An expert that has 1 follower.

Hot-Shot:

An expert who has answered 20 questions.

Joined: Apr 25, 2010
Answers
24
Questions
0
Helped
11710
Points
48

Just try some patience. Smoke a cigarette and plan your attack but don't get angry.

Anonymous

Level 1:

An expert who has achieved level 1.

New Friend:

An expert that has 1 follower.

  • Contributor 2 Answers
  • Posted on Apr 13, 2013
Anonymous
Contributor
Level 1:

An expert who has achieved level 1.

New Friend:

An expert that has 1 follower.

Joined: Apr 13, 2013
Answers
2
Questions
0
Helped
427
Points
2

Use two extensions on a racket with a 10mm socket just place socket on nut first because bolts abit long that's all ok

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

Ive got a 93 mazda mx-6. the motor came out of a 97 ford probe 2.0. with that being said.. 2 days ago, i drove it down a bumpy road (slow) at a coast. it dies and won't start. ive looked everywher

According to the wiring diagram, there is no inertia switch on a Mazda MX-6. The fuel pump circuit only has a pump relay which is powered by a fuse and grounded by the computer.
And if the car did have an inertia switch it would not affect the ignition system.
If you have no spark and no fuel pressure I would check the circuits for the pump, coil, and computer at those fuse locations and beyond. Could have shaken something loose at the key switch or in the wiring.
1helpful
1answer

I have a 93 Mazda mx6 Ls... Everytime I step hard

When my MX6 was doing this it turned out to be an hydraulic leak from the clutch master cylinder, which runs on the same fluid reservoir as the brakes. Clutch master cylinder replaced and all good again!
0helpful
1answer

Where is my diagnostics connection located on my 93 mazda mx6 4 cylinder?

For 1993 Mazda MX-6 2.0L MFI DOHC 4cyl the OBD Diagnostic Link Connector is located: Under hood, driver side, upper engine area, passenger side rear of air filter housing, mounted next to airflow meter connector.

Hope this helps (remember to rate this free answer)
.
0helpful
1answer

Cruise control does not work. Indicator light on instrument panel lights up with no response.

on my mx6 i noticed a crimped air line that attaches to the front of the air filter box.i installed new piece of air line (apprx.2 feet) and my cruise works great
2helpful
1answer

Where is the fuel filter located ?

For 1996 Mazda MX-6 2.5L MFI DOHC 6cyl the Fuel Filter is located under hood, driver side, engine side of strut tower, below air filter housing, mounted in fuel line.

2def6e0.jpg

Fig. 1: Exploded view of a typical 4-cylinder engine fuel system


63af5f0.jpg

Fig. 2: Exploded view of a typical 6-cylinder engine fuel system

Hope helps with this; remember rated this.
0helpful
3answers

93 mazda mx6 wont run. will start but runs very rough and only for a few seconds. plugs are black and getting too much fuel. I replaced the fuel pump, fuel filter, fuel pressure regulator. I think the...

the tps may affect the idle, but not really the excessive fuel. check that your coil has enough spark, remove plug watch spark. otherwise check haul senders in distributor or check injectors are not leaking.
0helpful
1answer

Sensor directly behind the air filter

93??? think its a carburettor
0helpful
1answer

I have a 1993 Mazda MX-6 LS and the odometer just stopped working suddenly. the speedometer works fine. why did this happen and how do I fix it?

you need to replace the board behind the cluster i haveone they are no longer found at the dealer if you email me i can see if its the right one
0helpful
1answer

Running rough

most likelly when your fuel pump gets hot it looses the pressure going to engine replace fuel filter and if this dont help then have the fuel pressure test done when problem is present
and if not good replace fuel pump
Not finding what you are looking for?

339 views

Ask a Question

Usually answered in minutes!

Top Mazda Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...