I added fluid for the windshield wipers but the rear does not work? Is there a different resevoir for the rear wipers of a 2005 GMC Yucon?

"If the windshield wiper fluid of your Chevy Equinox ends up on the rear window instead of the windshield, there could be several possible causes:

Damaged or incorrectly connected windshield wiper fluid tube: The tube that carries the windshield wiper fluid from the reservoir to the base of the front windshield wiper may be damaged or not connected properly, causing the fluid to leak elsewhere.

Clogged windshield wiper fluid outlet: The outlet of the windshield wiper fluid on the base of the front windshield wiper may be clogged with dirt or debris, causing the fluid to flow onto another part of the car, such as the rear window.

Windshield wiper system issues: There may be a problem with the windshield wiper system of your Chevy Equinox that causes the fluid to leak onto other parts of the car instead of the windshield."

Rear Wiper/Washer System Components
The rear wiper/washer system consists of the following components:
• Rear wiper/washer switch
• Window wiper module-rear
• Window washer pump-rear
• RR WIPER 15A fuse
• RR WPRB 25A fuse
Rear Wiper/Washer System Operation
The rear wiper module controls rear wiper motor operation. Battery voltage supplied to the module is used to operate the wiper motor in all modes and to return the rear wiper arm to the park position after the ignition is turned off. Accessory voltage supplied to the rear wiper/washer switch is used to supply the rear window wiper and washer switch signal circuits. In wiper switch positions 1 and 2 the wiper switch signal circuit voltage level to the wiper motor module determines the wiper motor delay interval. The rear window washer pump supply voltage circuit is used to provide the operating voltage for the rear washer pump for as long as the rear washer switch is pressed. The rear window washer switch signal circuit is used as a wash signal to the rear wiper motor module to operate the wipers during the rear wash operation.


Did you replace the rear wiper module ?

omg please, I cant stop crying... stop it

there is no rear resevoir. you just fill up as you would normally under the hood.

go to a service station with an air compressor and with the air turned down to about 20 lbs blow into the washer top small hole to force fluid thru the hoses,not a lot of pressure so you blow hoses off or rupture something

check around the back hatch there might be one back there if not look in the owners manual

check you rear wiper motor and make sure there fluid going to the motor

it might be in the motor pump or line is clog can you work the hose

I'm pretty sure it's the same as the front washer, You can check by see ing if there are two pumps in the front washer resevoir, if not there is a possiblity that there is a bottle in the back, servicable by opening the rear door and looking at the walls behind the tires. I hope this helps

Pretty sure the same reservoir feeds both pumps.