Can I reset or find my door code without paying dealership? It's not behind the fuse box, not behind the radio as other posts have stated.
Location of Keyless Code on Computer Module of Ford F250 Superduty (
2009 )
Finding this code seems to be a common problem, so, here is a better
answer to save you the time I spent locating the sticker on the computer
module that shows the keyless entry code.
One owners from 2008 F150 XLT Superduty tell me and I suspect the location for a F150
would be very near same location as on a F250
The computer module is mounted high on the firewall approximately behind
the a/c fan speed control knob. Here is how to find it / get to it:
1. Remove the large cover under the steering column that covers the fuse
block. You'll need to reach in under the dash, with your left arm, to
the right of the steering column and left of center to move stuff to get
a clear view.
2. Open the storage pocket door on the lower edge of the dash (right of
the steering column) and squeeze the back side of the storage pocket to
allow the stops to pass to the front. This will allow the opening to be
clear to see the computer module up in the dash. Shine your flash
light through this opening.
3. Move the first piece of white insulation to the side to see the
firewall. Look up through the pocket door, moving the wiring harnesses
aside if necessary. You'll find a second white insulation wrapped
snugly across the computer module. When you push the insulation up to
see the flat surface, you see the 5 digit number printed up-side-down in
black on a white sticker. This is your keyless entry code.
Instructions for Programming Keyless Entry Code (from the 2008
Owner's Manual)
KEYLESS ENTRY SYSTEM (IF EQUIPPED)
You can use the keyless entry keypad to lock or unlock the doors without
using a key.
The keypad can be operated with the factory set 5–digit entry code; this
code is located on the owner’s wallet card in the glove box, is marked
on the computer module, and is available from your authorized dealer.
You can also create your own 5–digit personal entry code.
When pressing the controls on the keypad, press the middle of the
controls to ensure a good activation.
Programming a personal entry code
To create your own personal entry code:
1. Enter the factory set code. The driver door will unlock.
2. Within five seconds press the 1 • 2 on the keypad.
3. Enter your personal 5-digit code. Each number must be entered within five seconds of each other.
4. The doors will lock then unlock to confirm that your personal keycode
has been programmed into the module.
Tips:
• Do not set a code that uses five of the same number.
• Do not use five numbers in sequential order.
Good Luck (remember comment and rated this).
This was the best overall instructions that i have come across period!!! It was located on my 2006 f-350 's computer module which is black in color that is attached to the firewall. Thank you.
Thank you for using FixYa, have a nice day.
this worked great for adding another code but now there are 2 codes that unlock the doors, the factory code and my personal code. Is there any way to erase the factory code so that I know that no one else can access my vehicle using the published factory code? ( I bought the truck used from a private party)
×
6,773 views
Usually answered in minutes!
×