Electric fuel pump is in that gas tank. you can do this 2 ways. one is take the bed off. un hook all your wires and remove the bolts out of the bed then get 3 buddies and remove the bed. so you can get to the top of the tank to get the fuel pump. or you can get a floor jack and support the tank and remove the tank straps and slowly ease the tank down so you can unhook the wires and hoses. then remove the tank all the way and work on removing the pump.
The easiest way is to take bed off.. its easier and faster and you have more than enough room to work i did it that way on mine...
SOURCE: fuel pump
On all Trooper II models the fuel pump is located in the fuel tank, fuel tank must be removed to access.
SOURCE: I need to replace the fuel pump in my 1985 Chevy S10 Pickup.
EXACT PROCEDURE ! Please Rate Me Fairly for this!! Thank you And Good Luck !!
ELECTRIC PUMP
REMOVAL
INSTALLATION
MECHANICAL PUMP
REMOVAL and INSTALLATION
NOTE: To ease pump installation, rotate the camshaft so the camshaft eccentric is out of the way of the fuel pump rocker arm.
SOURCE: the fuel pump is direct wired to the fuse box and stays on after truck is running
It needs to be wired to the keyswitch.
You can also put a toggle switch inline, and turn it on and off manually.
SOURCE: 1990 holden rodeo /isuzu pick-up temp sender
from memory it is in inlet manifold some were in front middle section bottom, (underneath) 4ZE1?
single wire possibly yellow
SOURCE: Where is the fuel filter located on a 1990 Isuzu
The filter is located on the frame rail by the passenger side rear wheel.
1,741 views
Usually answered in minutes!
×