Blinking green drive light

Reset oil service light Honda Pilot. From years: 2003, 2004, 2005, 2006, 2007, 2008, 2009, 2010, 2011, 2012.
How do you reset oil service light Honda Pilot. From years: 2003, 2004, 2005.

1. Turn off the engine. Press and hold the SELECT/RESET button in the instrument panel and turn the ignition switch to run (one position before starting).
2. Hold the button for at least 10 seconds, until the indicator resets.
3. Turn the ignition off and then start the engine to verify the indicator has been reset.

How to reset oil service light Honda Pilot. From years: 2006, 2007, 2008, 2009, 2010, 2011, 2012.
Resetting the Engine Oil Life Display if maintenance service is done by someone other than your dealer, reset the maintenance minder as
follows:

1. Turn the ignition switch to the ON (II) position.
2. Press the select/reset knob repeatedly until the engine oil life is displayed.
3. Press the select/reset knob for about 10 seconds. The engine oil life and the maintenance item code(s) will blink.
4. Press the select/reset knob for another 5 seconds. The maintenance item code(s) will disappear, and the engine oil life will reset to 100.

All information is taken from the Honda Pilot owners manual.

what codes does it show ??

fixya, hybrid fixes.. wow......
double posted too,,,, back up one.

wendy dont fiddle about in any hybrid, there is High voltage there
lethal as H3LL. nor with Air bags, Read the FSM. first.
and post engine RPM at low oil pressure, and dont drive it.

Any poor performance of the transmission with indicator lights on the dash mean you have problems that need to be resolved immediately...

Open the bonnet on the engine bay where you will find the Automatic Gear box.On the top of the gear box you will find the solenoids with some connecting wiring,check whether are correctly connected.,Not well clipped?

A blinking Check Engine Light indicates that you have a missfire on one or more cylinders. yYou really shouldn't drive it untill you get it fixed because this can cause damage to your Catalytic Converters, and they are VERY expensive to replace.

IT IS FLASHING A TRANSMISSION CODE OR LETTING YOU KNOW THE TRANS. SYSTEM HAS DETECTED A FAULT IS IT DRIVING DIFFERENT IF SO YOU MAY WANT YOUR LOCAL SHOP WETHER DEALER OR INDEPENDENT LOOK AT IT MAYBE CHECK TRANSMISSION FOR DTC DIAGNOSTIC TROUBLE CODES UNLESS YOU HAVE THE ABILITY TO DO THIS YOURSELF

there is a problem with your transmission, have it check soon

To reset your light do the following:

1-Push maintence reminder button in and hold it in. (thats the button near the speedo on the insturment cluster)
2-Turn the ignition to the on position while holding button in.
3-Wait several seconds until the light goes out, then let go of the button.
It is now reset

Now this is the maintaince light and not the check engine light correct? If then just follow above and do that.

Also if you don't use Fram oil filters you can go 5000miles on your oil and be safe. Even honda says you can do 7000miles but 5000 gives you a buffer if you need to go over.

The light is blinking to let u know that an electronic failure has occured in the transmission, u may feel nothing wrong or it could fail next week, get it tested for the trouble code that is stored in the trans computer control module.