Reverse fuse - 2000 Mazda 626

All question need 'year make model' as first three words.

Google

year make model fuse box diagram

and

year make model blows number (?) fuse in reverse

It is likely to be the reverse switch that activates the reversing lights, or frayed shorted wires in the trunk.

..

Reverse fuse ???? For transmission reverse or reverse (back-up light's )

Possibly an internal failure of the reverse switch. The blown fuse is for both the reverse and the turn signal lights. The fix is replacement of the reverse switch.

The fuse is in the fuse box in the car, the hand book should tell you which fuse it is. If the fuse is OK, there is a switch on the front or top of the gearbox, should have two wires going to it. Could have come unplugged, if you bridge these wires and turn the ignition on, the reverse lights should come on, if they do, it's a faulty switch.

Check your reverse switch on the transmission to make sure its hook up . You will have to probably replace it . If you have not tried that first . Use a light meter to check the reverse switch if you have power at the plug then its the switch if theres no power then check your fuse box for blowen fuss

It's not that simple anymore . The transmission range sensor switch is what they have now . This range sensor informes the PCM - engine computer what gear the vehicle is in. When you put the gear selector into reverse B+ voltage from the range sensor to the PCM tells the PCM reverse has been selected , the PCM then will energize the reverse lamp relay (located in the under hood fuse/relay box) there by turning on the reverse lamps . There are two fuse's in the under hood fuse/relay box . F27 10amp. & F35 10amp.

The fuse for the reversing light on a 2002-2010 (K12) Nissan Micra is in the fuse box located in the engine bay.

There is a long column of 15 fuses on the right-hand side of the fuse box. The reverse light fuse is the 6th fuse from the bottom of that column. It's a 10A red fuse.

Please note the following if you plan to look this up in the service manual:

1. The service manual calls this fuse box the "IPDM E/R", which stands for "Intelligent Power Distribution Module Engine Room".

2. The service manual refers to the reversing light as the "Back-Up Lamp". This is also abbreviated as "BACK/L".

3. The BACK/L fuse is fuse number 50 in the service manual.

Hope this helps!

No they should only come on when you put in reverse or else everyone would think you were backing up! its your bulb if just one, the fuse if both or the reverse switch indicator... Good Luck

There is a fuse for the reverse lights. If you find that the fuse is good, have the reverse light switch checked, it's usually on the side of the transmission.