How to install a front license plate bracket on a 2001 Mitsubishi Eclipse.

First you need a license plate bracket that mounts to the bumper, and then you screw the license plate to the bracket.

Normally there are screws already holding your old plate in there...(4 corners)
If your car doesn't have plate, usually the front bumper has a license plate bracket on it- normally it is 2 parts : 1 fastened to your car, the other comes off and you put your plate in between them and screw all of them back together.

If your car doesn't have a bracket, then it's prob a new bumper, so you can go buy one and you just drill it on (it'll have instructions if you have to buy 1) Just make sure you center it and it's straight.

You will have to install an after market license plate holder, as Mitsubishi Eclipse spyder does not have a front plate holder. Where you install it on your bumper is up to you , but remember to follow your local laws in regards to placement and the proper amount of screws holding the plate.

hi, yes, you can buy an universal license plate mounting frame at any auto part store, it comes with all the hardware you need, you can use a tape measure and small level to get it centered....

Not that difficult...either go to any scrapyard and take a bracket off a wreck, or simply drill through the bumper and attach with screws. Either will work just fine!

I had the bracket upside down was the problem and now is attached properly

License plate mounting bracket/front.

well u will have to drill holes though the bumper and use the supplied screws that came with the kit u might have to use washers on both sides of the screws of the license plate but that should work for ya

If your State doesn't require it, why install it?
If your State does require a front plate, and you just bought the car, take it back to the dealer. They are required by law to install the plate before selling it.

Any auto store can sell you mounting hardware for your front plate. If you look at your front bumper, you should see two little dimples in the center of the bumper, these will line up with your plateholder. Make sure it does and drill there, and mount with proper hardware.

there is an actual liscence plate bracket u can buy at a chrysler dealership thats fits perfectly on bumber it has teeth that perfectly center the bracket right below the grill it looks great i just had one put one on my 2005 300