SECTION 417-01: Exterior Lighting
2007 Expedition/Navigator Workshop Manual
REMOVAL AND INSTALLATION
Procedure revision date: 08/10/2006
Headlamp Bulb 
Printable View (255 KB)
Expedition Heahow do I replace the headlight bulbs on my 2007 - n0057191.gifc="/uploads/images/n0057191.gif" alt="n0057191.gif" class="h_mi" />
Item
Part Number
Description
1
13006/13005
Headlamp assembly (LH/RH)
2
13N021
Headlamp bulb
how do I replace the headlight bulbs on my 2007 - n0057192.gifigh Intensity Discharge (HID) Headlamp Bulb
Item
Part Number
Description
1
13N019
HID bulb access cover
2
—
HID bulb screws (2 required) (part of 13A006)
3
13N021
HID bulb
4
WARNING: The headlamp bulb contains gas under pressure. The bulb may shatter if the glass envelope is scratched or if the bulb is dropped. Handle the bulb only by its base. Avoid touching the glass envelope. Failure to follow these instructions may result in personal injury.
NOTE: The headlamp bulb should not be removed from the headlamp until just before a new bulb is installed. Removing the bulb for an extended period of time may affect headlamp bulb performance. Contaminants may enter the headlamp where they can settle on the lens and reflector. Never turn on the headlamp with the bulb removed from the headlamp.
NOTE: Make sure that the headlamp switch and the ignition switch are in the OFF position.
All vehicles
Expedition
Navigator
All vehicles
SOURCE: headlight bulb replacement
it should come out of the back of the housing just turn it one way or the other and pull it out or there is a keeper holding it in
SOURCE: headlight bulb replacement 2005 ford expedition
open the hood push the headlight housing retaining clips rearward and then pull upward on the clip to release the headlight housing and pull the housing out and away from car to access the bulb retaining ring located on the back side rotate the bulb retaining ring counterclockwise and pull the bulb socket assembly out of the housing and when installing the new bulb do not touch the bulb surface if you do wipe with rubbing alcohol
SOURCE: 2007 Forrester - headlight bulb good but not lighting
You will need to look at the plug for the headlight. If it looks good, I would look for the headlight low beam fuse.
SOURCE: want to replace bulb in headlight in 2007 saturn outlook how hard is it"
It's not hard. Open the hood, locate the backside of the lite thats out(follow the wires) give the housing a slight counter-clockwise turn to remove it.
The bulb should pull out. Use a tissue to re-install the new bulb, as the oils on your fingers will cause the new one to overheat and burn out, prematurly
SOURCE: replace headlight bulb on 2007 xc70
Get a Haynes manual for the vehicle, it will show you everything you need to know. Online or auto parts store.
1,130 views
Usually answered in minutes!
×