Last night I hit my compass agaist another car. It was not so hard but know the car won start. I think I need to reset the computer: How do I do it
How do I reset my computer on my 2007 jeep compass
SOURCE: Temperature/compass display no longer works, any suggestions?
Number one..,
Id check the fuses then if still you have no luck id check that the unit is getting power by using a circuit tester or voltmeter ect...
Let us no how you get on...
Jules...
SOURCE: calibrating compass
Yes you can.What you have to do is press the mode button on the driver info center(DIC).Press and hold the set button for 3 seconds.The DIC will display the zone.This is what part of the country you live in.What state your in.I don`t know what Zone your in so I don`t know if it is in the correct zone or not.They go from i-15.This will determine how accurate your compass will be.If you press set it will change the zones.If it is the correct zone then press the mode set button til the DIC displays calibrate compass.Press set and the DIC will tell you to drive in circles.Find a large empty parking lot to do this.I just crank the steering wheel and keep going in circles.The DIC will say calibrating.When the compass shows direction and temperature it is done calibrating and you can stop driving in circles.Hope this helps.Good luck.If you need to know what Zone your in Just post back with the state you live in and I can tell you the zone.
SOURCE: temp and compass stopped working
The overhead console is quite prone to internal failure. Dim, intermittent, or dead displays are a common symptom of an internal failure. We offer a reasonable repair service with a lifetime guarantee. Check it out: www.autoclockrepair.com
Figure 1 - Variance Settings
2.
Turn the ignition switch to the On position. If the compass/thermometer data is not currently being displayed, momentarily depress and release the C/T push button to reach the compass/thermometer display.
3.
On Electronic Vehicle Information Center (EVIC) and Compass Mini-Trip Computer (CMTC) equipped vehicles depress the Reset push button and hold the button down until "VAR = XX" appears in the display. This takes about five seconds. On Compass Temperature Module (CT) equipped vehicles depress the C/T push button and US/M push button down until "VAR = XX" appears in the display. This takes about five seconds.
4.
Release the push button(s). "VAR =XX " will remain in the display. "XX" equals the current variance zone setting.
5.
On Electronic Vehicle Information Center (EVIC) and Compass Mini-Trip Computer (CMTC) equipped vehicles momentarily depress and release the STEP button to step through the zone numbers, until the zone number for your geographic location appears in the display. On Compass Temperature Module (CT) equipped vehicles depress the US/M push button to step through the zone numbers, until the zone number for your geographic location appears in the display.
6.
On Electronic Vehicle Information Center (EVIC) and Compass Mini-Trip Computer (CMTC) equipped vehicles momentarily depress and release the RESET push button to enter the displayed zone number into the EVIC/CMTC module memory. On Compass Temperature Module (CT) equipped vehicles depress the C/T push button to enter the displayed zone number into the electronic module memory.
7.
Confirm that the correct directions are now indicated by the compass.2,578 views
Usually answered in minutes!
×