Change headlinght bulb

SECTION 417-01: Exterior Lighting 2005 Freestyle/Five Hundred/Montego Workshop Manual REMOVAL AND INSTALLATION Procedure revision date: 03/14/2005 Headlamp Bulb Printable View (327 KB) Freestyle, Five Hundred
Item Part Number Description 1 — Headlamp bulb electrical connector (part of 14290) 2 13N021 Headlamp bulb

Mochange headlinght bulb - n0035266.gifc="/uploads/images/n0035266.gif" alt="n0035266.gif" class="h_mi" />
Item Part Number Description 1 — Headlamp bulb access cover screws (6 required) (part of 13006) 2 13N019 Headlamp bulb access cover 3 — Spring retainer (part of 13006) 4 13N021 High intensity discharge (HID) bulb 5 14A411 HID bulb electrical harness 6 — High beam bulb electrical connector (part of 13006) 7 13N021 High beam bulb Removal achange headlinght bulb - ani_caut.gifion
WARNING: The headlamp bulb contains gas under pressure. The bulb may shatter if the glass envelope is scratched or if the bulb is dropped. Handle the bulb only by its base. Avoid touching the glass envelope. Failure to follow these instructions may result in personal injury.
NOTE: The headlamp bulb should not be removed from the headlamp assembly until just before a new bulb is installed. Removing the bulb for an extended period of time may affect headlamp bulb performance. Contaminants may enter the headlamp assembly where they can settle on the lens and reflector. Never turn on the headlamps with the bulb removed from the headlamp assembly.
NOTE: Make sure the headlamp switch and ignition switch are in the OFF position.
Freestyle, Five Hundred

1. Rotate the headlamp bulb 1/8-turn counterclockwise and remove the headlamp bulb.
   • Disconnect the electrical connector.

1. Remove the headlamp assembly. For additional information, refer to Headlamp Assembly — Five Hundred, Montego in this section.

1. Remove the 6 screws and the headlamp bulb access cover.

1. Rotate the headlamp bulb 1/8-turn counterclockwise and remove the headlamp bulb.
   • Disconnect the electrical connector.

1. Release the spring retainer and remove the HID bulb.
   • Disconnect the electrical connector.

1. To install, reverse the removal procedure.