2009 Nissan Altima Hybrid Logo

Related Topics:

Anonymous
Anonymous Posted on Mar 29, 2010
Answered

HI, I HAVE AN ALTIMA 1995 WITH HIGH ACCELERATION ISSUE. I DISCONNECT THE CHECKVALVE AND THE ACCELERATION GET DOWN , BUT INCONSISTENT,,, THANKS IN ADVANCE FOR YOUR HELP...

Answer This Question
  • 1 more comment 
  • Anonymous Mar 29, 2010

    HI,YES, THE HIGH ACELERATION IS UP ON IT'S OWN, AND NOT GET DOWN UNTIL I DISCONNECT THE SENSOR THAT IS BETTWEN THE AIRCLEANER AND THE HOSE THAT GO TO THE CARBURATOR...

  • Anonymous Mar 29, 2010

    YES THE HIGH ACELERATION IS ON IT'S OWN AS SOON I START THE CAR. AND GET DOWN BUT INCONSISTENT UNTIL I DESCONNECT THE SENSOR TAHT IS BETTWEN THE AIR CLEANER FILTER AND THE CARBURETOR ( ON THE HOSE),,,

  • Anonymous May 11, 2010

    What checkvalve are you refferring to? The PCV Valve? Is the High Acceleration Issue the engine revving up on it's own?Need more information , please.

×

1 Answer

Anonymous

Level 2:

An expert who has achieved level 2 by getting 100 points
MVP:

An expert that got 5 achievements.
Sergeant:

An expert that has over 500 points.
Governor:

An expert whose answer got voted for 20 times.

  • Expert 184 Answers
  • Posted on Mar 30, 2010
Anonymous
Expert
Level 2:

An expert who has achieved level 2 by getting 100 points
MVP:

An expert that got 5 achievements.
Sergeant:

An expert that has over 500 points.
Governor:

An expert whose answer got voted for 20 times.

Joined: Mar 12, 2010
Answers
184
Questions
1
Helped
64442
Points
526

Sorry, for the slow response. That sensor your refferring to
is the MASS Airflow Sensor,which seems to be bad. Take the
sensor off the air intake hose and see if anything is stuck in the
element. It is very delicate,so be careful. Reconnect it and if you have a digital multimeter,check to see if the voltage across the
power side is no more than 5 volts. I'm betting it's bad. Good luck.

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

High acceleration on mercury 90 is inconsistent. Gets going and power drops intermittently.
If this is a boat question you may want to repost it in the boat section.
Read full answer
Sep 26, 2012 • Cars & Trucks
1helpful
1answer

98 nissan altima shakes when i come to a stop and sometimes cuts off
If you also have rough idle or inconsistent idling as well you may need the IAC valve checked. Some of the shops would let you borrow their scanner, see if you can retrieve error codes, the error codes would help you accurately identify the part that may be going bad.
Read full answer
May 19, 2011 • 1995 Nissan Altima
0helpful
3answers

When I drive my car it sound as if the motor is straining, as I excelerate the noise increases with acceleration. I believe it is idled too high, how high is it supposed to be.(2001 nissan altima)? ...
4- 600 rpms idle maybe
Read full answer
Mar 16, 2011 • 2002 Nissan Altima
10helpful
1answer

Howm do I replace a starter on a 1995 Nissan
Nissan 240SX/Altima 1993-1998 Repair Guide

Altima
(see Figures 1, 2 and 3)


ef972ea.jpg
Fig. 1: The starter is located to the left of the oil filter housing on the engine block


dfca7b3.jpg
Fig. 2: The starter motor is removed from the bottom side of the engine compartment


04c206e.jpg
Fig. 3: When installing, be sure to align the starter's mounting bolt holes with those in the engine block
  1. Disconnect the negative battery cable.
  2. Raise and support the vehicle safely.
  3. Remove the starter support bracket, as required.
  4. Label and disconnect the starter electrical harness.
  5. Support the starter from beneath the vehicle using a jackstand.
  6. Remove the starter mounting bolts.
  7. Carefully lower the starter from the vehicle.
To install:
  1. Position the starter on the engine and support it using a jackstand.
  2. Install the starter mounting bolts and tighten to 30-37 ft. lbs. (40-50 Nm).
  3. Connect the starter electrical harness.
  4. Install the starter support bracket, as required.
  5. Lower the vehicle.
  6. Connect the negative battery cable.

Hope helped with this (remember rated this help) Good luck.
Read full answer
Nov 27, 2009 • 1995 Nissan Altima
0helpful
1answer

Rover 414 sli,1995,Tickover is high and inconsistent, fluctuating
try your idle control valve/sensor
Read full answer
Nov 03, 2009 • 1999 Honda Civic
0helpful
2answers

The engine seems to have oil, but the light is on in my 1995 nissan altima
The oil light means you have low oil pressure but not necessarily low oil.
Low oil pressure can lead to serious engine problems and should be fixed right away.
Read full answer
Jun 17, 2009 • 1995 Nissan Altima
0helpful
2answers

1995 Buick Lesabre custom stalling and idle
did you clean the idle speed control air bypass valve?, u do this by spraying carb spray into the intake while the engine is held at hi idle so it won't stall, use up about half the can, then shut down and disconnect battery for 5 minutes to reset system idle learn, drive the car for a few days and let me know if the problem is fixed.
Read full answer
Mar 24, 2009 • 1995 Buick LeSabre
6helpful
1answer

When I try to accelerate my car has no power!
There could be a couple of reasons. Yes a tune up would be nice. But my not fix the problem. If you are not losing acceleration on straight away but on hill, then it could be the torqe converter. Also have your MASS airflow sensor checked and air filter.

Also check your fuel pressure at the fuel rail. Get a fuel gauge and look for a port on the fuel rail for a port that looks like the valve on the tire. Screw it in and crank the car. You will have to call the part store to find out what pressure it is supposed to be. If there is low or eratic pressure the its the filter or pump
Read full answer
Jan 20, 2009 • 1995 Nissan Altima
0helpful
1answer

Failed exhaust emission tests on Nissan Sunny N14 eng 1600
Clean the MAF (mass air flow sensor.)Follow the hose from the air filter to the air flow sensor.Use a proper cleaner rated safe for this purpose.
Read full answer
Jun 25, 2017 • 1995 Nissan Altima
0helpful
1answer

Blower motor out on my 95 altima
You should be able to remove wire harness, & screws holding it in there & just lower it down & out, but you may have to remove glove box first to get at it all.
Read full answer
Jan 02, 2009 • 1995 Nissan Altima
Not finding what you are looking for?

View Most Popular

2009 Altima Hybrid

  • Cars & Trucks

Related Question

High acceleration on mercury 90 is inconsistent. Gets going and power drops intermittently.

  • Cars & Trucks

Related Topics

118 views

Ask a Question

Usually answered in minutes!

Popular Questions

I need to know if

Nissan Altima Hybrid Cars & Trucks

DIGRITZ! THIS IS DIGRITZ ONLY. I HOPE YOU SEE

2009 Nissan Altima Hybrid

When I let off the accelerator on my 2009 Nissan

2009 Nissan Altima Hybrid

I have a 2010 Nissan Altima Hybrid 63,000 + miles. I was driving and it just started decelerating and finally stopped. All electronics come on and the gear shift is movable. What's wrong with my car?

2010 Nissan Altima Hybrid

Nissan almera 1.5letre 2005.code po725

Nissan Altima Hybrid Cars & Trucks

Check Out the Latest Top Trucks Report!
Check Out the Latest Top Trucks Report!

View all Fixya Reports

Top Nissan Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...