-
Pontiac Master
17,989 Answers
- Posted on Mar 26, 2010
Re: Need location on blower motor resistor on 1994...
Fig. 1: The blower motor and fan assembly is mounted in the heater
and A/C module, and is accessible from the engine compartment
GM Bonneville/Eighty Eight/LeSabre 1986-1999
Blower Motor - REMOVAL & INSTALLATION
(see
Figures 1 and 2)
-
Disconnect the negative battery cable.
-
If necessary, tag and disconnect the number 2, 4 and 6 spark plug
wires from the ignition coil and move the coil out of the way.
-
For 1993-99 vehicles, remove the nuts and cross brace bar.
-
Detach the electrical connections from the blower motor.
-
Disconnect the cooling tube from the blower motor.
-
Unfasten the screws securing the blower motor to the blower module
assembly.
-
Remove the blower motor and fan assembly from the module.
-
If necessary, unfasten the nut attaching the fan to the blower
motor shaft, then pull the fan from the blower motor.
Fig. 2: You can disassemble the fan from the motor by removing the
retaining nut
To install:
-
If the fan was removed from the motor, position the fan on the
shaft, then install the retaining nut. Tighten the nut to 12 inch lbs.
(1.4 Nm).
-
Position the blower motor and fan assembly to the module, then
install the retaining screws. Tighten to 5 inch lbs. (0.6 Nm).
-
Connect the cooling tube to the blower motor.
-
Attach the electrical connector to the blower motor.
-
On 1993-98 vehicles, install the cross brace bar and retaining
nuts. Tighten the nuts to 18 ft. lbs. (25 Nm).
-
If removed, install the coil and connect the spark plug wires, as
tagged during removal.
-
Connect the negative battery cable.
Hope this helped (remember rated and comment this).
×