Question about 1999 Ford Mustang Cobra

2 Answers

Is their a download or directions anywhere showing how to replace a fuel pump on a 99 ford mustang

Posted by csturman on


2 Answers

Wayne Fellows

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Ford Expert
  • 262 Answers

WARNING: Do not smoke, carry lighted tobacco or an open flame of any type when working on or near any fuel-related components. Highly flammable mixtures are always present and may be ignited, possibly resulting in personal injury.
WARNING: Fuel supply lines on all vehicles equipped with fuel injected engines will remain pressurized for long periods of time after engine shutdown. Fuel system pressure must be relieved prior to fuel system service to prevent possible personal injury or a fire hazard.

!!You need a FORD connection remover tool for all hoses with the release type mechanism on them. This kit has several "C" shaped plastic buttons that insert into the lines to release them from their connections. Around $20.00 for kit available at most part stores.

  1. Disconnect the battery.
  2. Relieve the fuel system pressure.
  3. Drain the fuel tank.
  4. Raise the vehicle.
  5. Remove the filler pipe bolt attachment and disconnect the filler pipe hose connections to the fuel tank. is their a download or directions anywhere showing - 15e2436.gif
    6.Disconnect the fuel tank electrical connector.
    7.Disconnect the vapor tube fitting at the left front of the fuel tank. is their a download or directions anywhere showing - 9fe01ac.gifmg src="/uploads/images/9fe01ac.gif" alt="9fe01ac.gif" class="h_mi" /> is their a download or directions anywhere showing - the EVAP canister tube and hose.

    9f1ed77.gif 9.Place a safety support under the fuel tank.
    10.Ris their a download or directions anywhere showing - 7a22b14.gifront two bolts from the fuel tank support straps and swing the LH strap out of the way.
    is their a download or directions anywhere showing - 582b83c.gifimg src="/uploads/images/7a22b14.gif" alt="7a22b14.gif" class="h_mi" /> 11.Remove the RH fuel tank support strap bolt and remove the strap.

    1. Partially lower the fuel tank and disconnect the fuel line. CAUTION: The filler pipe grommet must be removed prior to removing the fuel tank from the filler pipe or damage to the fill tube check valve will their a download or directions anywhere showing - a384f0b.gifclass="h_mi">Cut outer edge of pipe-to-tank grommet to facilitate pipe removal and carefully remove the grommet from the fuel tank. Take care to avoid damage to the fillis their a download or directions anywhere showing - 45c1b43.gifck valve.


    14.Clean the area around the fuel delivery module mounting flange.
    15.Remove the module assembly flange bolts.

    45c1b43.gif 16. CAUTION: The fuel delivery module must be handled carefully to prevent damage to the floais their a download or directions anywhere showing - 56a3992.gifer, convolute tubing and wiring.
    Pull the fuel delivery module assembly flange up and out of this their a download or directions anywhere showing - f1eaa17.gif until the locking tabs on the module are accessible. Reach through the opening and squeeze the locking tabs together and remove the module from the fuel tank by lifting up and out.

    I hope this is clear enough to follow. Please give thumbs up feedback to me if it is..wff1eaa17.gif

Posted on Mar 27, 2010



  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.


    An expert that has over 500 points.

  • Expert
  • 267 Answers

Buy a Haynes manual online or at an auto parts store. It will show you everything you can work on on your car. They take cars completely apart and take photos all the way, then put it back together. I have one for each of my vehicles.

Posted on Mar 25, 2010


Add Your Answer


Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

2 Answers

How to check pcm, no spark,no fuel, no injection pulse.99 ford mustang 3.8 v6

When you turn ignition key on ( not start ) does the checking light ,light ? Check fuse's for PCM , are they good ? Find a wiring diagram an check power an ground at PCM . Also hook up a scan tool an see if it will communicate with the PCM . That's how you check the PCM ! Also check the constant control relay module , these go bad an they have fuel pump relay , power hold relay , this powers up fuel injectors an ignition system !

Jan 08, 2016 | Ford Cars & Trucks

2 Answers

Pump relay location

sounds like the immobilizer is locking out the fuel pump,
have you replaced the key without reprogramming it?if so take the old key and the new tape them together at the tops cut portions facing in opposite directions and try starting the car that way the security light should go out

Aug 06, 2014 | 2001 Ford Mustang V6

1 Answer

99 mustang where is fuel pump relay?

The fuel pump relay is inside the c.c.r.m (constant control relay module) located on a bracket behind the coolant overflow bottle...turn key on and off a couple times and see if you hear a clicking noise from relay. .if not "slightly"tap the box and see if fuel pressure retu

May 18, 2014 | 2001 Ford Mustang

1 Answer

How do i remove the gas pump from the tank on a 99 ford mustang

first, disconnect the battery, raise and support rear of car on jackstandsdisconnect all hoses wiring connectors from fuel tank. support fuel tank with a suitable jack loosen and remove straps holding the fuel tank and lower tank, using a BRASS punch remove the lock ring on top to remove fuel pump assembly being careful not to damage or misalign float assembly. install in reverse order. connect battery check for leaks. Good luck.

Mar 22, 2013 | 1999 Ford Mustang Cobra

1 Answer

My 99 mustang cobra want start. it turns but want start. I parked it last night when i came home and now it want start.

check to see if fuel pump is running when key is turn on. also check fuses to pump or ignition

Jan 23, 2011 | 1999 Ford Mustang Cobra

1 Answer

I have a 99 ford mustang and it when into theft mode i check battery even the fuel pump and wont start what do i do?

locking & unlocking the doors will reset the anti theft.
Or disconnect battery for an hour and see if it resets.

Jan 20, 2011 | 1998 Ford Mustang

1 Answer

Its a 99 GT, the engine winds over but dosent start, Ichecked the relay in the boot & checked & switched the relays under the hood, is there a fuse anywhere as well? if so , where? the car only has...

Fix the Ford P1233 FPDM Fuel No Start Problem Here's a fix for that no-start condition on 2004-2008 Ford trucks. The FPDM (fuel pressure driver module) usually shows up as a P1233 diagnostic trouble code (OBD-II) when the truck's codes are read. A Ford P1233 code is described as Fuel Pump Driver Module Offline or Fuel System Disabled or Offline. A search on Google for Ford P1233 shows that this P1233 DTC code is not limited to being a problem on just Ford trucks. Others with the Focus, Mustang, Town Car, etc. also experience this problem.
You may experience stalling, no-starts, random no-starts, or other potential symptoms. A quick search over at (a Ford service web site), they offer the following possible causes if the P1233 code is triggered:
  • Inertia fuel shutoff (IFS) switch needs to be reset.
  • Open FPDM ground circuit
  • Open circuit to FPDM PWR RLY
  • Open FPDM PWR circuit
  • Open or shorted FPM circuit (engine should start).
  • Damaged IFS switch. try link hope this helps it may be it would hate for you to change fuel pump and it not be fuel pump

Dec 08, 2010 | 1999 Ford Mustang Cobra

1 Answer

How to replace electric fuel pump on 99 ford mustang v6 3.8

chilton make a great bible for your car that will help it's sold at chapters

Jan 06, 2010 | 2000 Ford Mustang

3 Answers

1988 ford mustang fuel system

I had two vehicles in the last month do this and when i dropped the fuel tank the rubber line in tank between the pump and pickup tube was broke not alowing fuel to be sent to engine

Sep 26, 2008 | 1988 Ford Mustang

1 Answer

1998 ford mustang gt

Have you checked fuel pressure regulator.Getting fuel out of injectors? Did you replace old pump with a new good quality pump?

Sep 26, 2008 | 2003 Ford Mustang

Not finding what you are looking for?
1999 Ford Mustang Cobra Logo

258 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts


Level 3 Expert

85239 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

gerry bissi

Level 3 Expert

4388 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides