Boot not opening with remote or indoor lever third brake light not working told by merc could have broken wire but i want to try fue first but cannot find which fuse no diagram eclass 220 cdi 06

Dodge Charger 3rd Brake Light ' eBay

www.ebay.com/bhp/dodge-charger-3rd-brake-light

eBayFind great deals on eBay for Dodge Charger 3rd Brake Light in Tail Lights. ... Will fit:2011 - 2013 dodge charger. ... I swapped this out for the third brake light W/ backup camera so I no longer need this one. Item is .... There are three wires; positive driving / strobe flashing blinker mode, positive backup / brake light mode and ...Missing: deck

3rd brake light not working - Lx Forums

www.lxforums.com/board/...php/155947-3rd-brake-light-not-working

Mar 15, 2009 - 12 posts - ‎3 authors
i would try and test if you even have power at the 3rd brake light. that way ... work, the circuit is working up to S348 splice where it splits to left/right/CHMSL. ... You'll have to undo the rubber boot to examine the wire. ... 2011 Dodge Charger R/T Plus AWD- Redline - 5.7L Hemi Registry #1650 Tbird100636

There is no fuse for the third brake light that I know of, it is wired into the main brake light wiring on most cars anyway. Probably the bulb is blown.

all of the brake lights are on the same fuse. If the other brake lights are working than the fuse is good.

If I remember correctly this third brake light is located in the trunk lid. I would suspect that there is a broken power or ground wire going to the socket for the bulb. The usually area for this to happen is where the wiring harness flexes when the trunk is opened and closed. I think the connector for the harness is in the same area and I'm pretty sure it is on the drivers side. Take a peak at the wiring in that area. you may have to remove some tape to get a good look. If there are wires broken than a simple repair should get it working again.

I’m happy to assist further over the phone at https://www.6ya.com/expert/jeremy_d728a59f986299fa

must have a wiring problem use a meter to see if your getting power to wiring on rear lights if not broken wire somewhere along the line could run a wire from third light might solve t your problem

CLS550 2010. Same complaint trunk won't open, third brake light and license plate lights not working. Two ground wires (Brown) were broken inside the bundle of wires right were the zip tie holds them to the trunk lid arm. When I first looked I missed them. Remove all the corrugated wire protection and look the wires over very closely. One of them was broken inside but the wire just looked kinked on the outside. The other was broken in too. 7/9/17

you have a broken wire some were if you cant find it you can run a seperate power wire from the third brake light to the brake lights but i would check for power at the brake lights first to make sure its not a ground problem

If the fuses or brake light switch were bad your third brake light would not work same with the multi purpose switch. you either have a wiring problem like some broken wires or the actual light sockets are bad. it is common with gm trucks that the circuit board for the tail lights melts and does not make contact.

THE PROBLEM IS IN THE MULTIFUNCTION SWITCH, REPLACE IT.

i found the solution to same problem here.
http://mbworld.org/forums/e-class-w211/314638-no-power-trunk-3rd-brake-light-license-plate-lamps-2.html
it was a easy fix, broken wires in the boot a common fault with mercedes.

Hurrah, I've managed to stop my fuse 46 blowing. The problem was the wire that run into the boot lid.  There is a thick bunch gathered together and a single wire that runs along side, im guessing this feeds the boot lid / spoiler brake light. anyhow that wire was broken and Im guessing would touch after the boot had been opened and closed.  Which is how i figured out the intermittent (could last a day or an hour) problem.
Hope this helps