Question about 1995 Toyota Corolla

1 Answer

Am2 30 amp fuse blowing

When i turn on the ignition on my 1995 Toyota EXIV the 30 amp fuse in the engine bay thats labeled AM2 blows. This causes total engine failure and no further use of starter motor

Posted by Peter Robert Neilson on

  • Anonymous Mar 24, 2014

    AM2 fuse keeps blowing out

×

Ad

1 Answer

Anonymous

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    New Friend:

    An expert that has 1 follower.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 55 Answers

Check the battery cables for wear and make sure they aren't grounding out on the frame you have a direct short and that is more than likely where it is

Posted on Mar 16, 2010

  • FoilRJr Aug 07, 2011

    I had the same problem. Found the condenser inside the distributor assembly had failed and created the direct short. I just removed it and all is well.

×

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

My 2000 Toyota Camry has coil packs and still keeps blowing am2 fuse

More than Likely, you have a Short on that System and it is causing the 2Amp Fuse to blow. 2 Amp's is not very much, there is getting more than 2 Amps and the most likely cause is a Chaffed Wire that is feeding back into the system...
0helpful
1answer

My hilux won't start keeps blowing the ignition fuse when turning the key on

that is a dead short, the fuse saved you the ensuing fire.
there are 2 fuses or more... with that name..
old cars love to short things, no lie.
the fsm is the best thing to have, and alldata.com , 2nd.
the older that car the more true that is... and your car is 10x that.
a 1991
is the fuse in the cab BOX? NOT ENGINE BAY?
THE CAB FUSE , HAS these (USA cars, other are DIFFERENT)
no country stated (sigh)
ignition sw AM1
ignition sw AM2
ignitor 1
ignition coil (1 for 4cy, and 1 for v6 engine, unsaid)
on one car there is a IGN fuse 7.5 amps
and runs the ECU and main relay.
there are 3 engines, and drawing for all 3.

get the fsm and use that or login to alldata.com and hope
it covers your engine. (unstated)
22r,3vz,3F
0helpful
1answer

Toyota tarago 94 wiring diagram

Could be a short circuit on ignition wires or a broken ignition switch. Or a short circuit on starter wires or inside the starter motor itself.
4helpful
2answers

30amp AM 2 fuse blows as soon you turn on the key & car will not start

This is common about this time on these Camrys. I own three. The AM2 fuse is blowing because a coil, capacitor, or supressor has gone bad in the distributor. To test this disconnect the two wire connectors to the distributor. Replace the AM2 fuse. Turn the ignition. If the fuse doesn't blow. The distributor.
0helpful
2answers

The AM2 fuse under hood keep blowing out every time i turn the ignition key switch to on position

I would disconnect the noise filter located by the ignition coil/ignitor, have seen them short out and cause the AM2 fuse to blow. Also Disconnect coil, dist and see if short goes away
3helpful
3answers

Why does me AM2 fuse blow on my 96 camry le 2.2

There is a capacitor/condenser that is used for noise suppression/static. It is attached to the post of the coil. They melt and short out blowing the AM2 fuse. You can clip the wire for now and it will run fine. The condenser can be purchased at the dealer for about $8 but the distributer has to come out to change it.
...stolen from another webby
0helpful
1answer

1993 pasco blowing am2 fuse

a wire is shorting to earth so blowing fuse or what ever is on the fuse blowing circuit is drawing excessive current
2helpful
2answers

No spark/no fuel.1995 toy. camry 2.2 5S=FE

The BONNET is the hood, You must have talked to someone from ENGLAND. The fuse may blow if the coil or the igniter is shorted. Turn the key on and disconnect the igniter and coil, then hook up each one and see when the fuse blows.
0helpful
1answer

No start, blown ignition fuse 30 amp.

If it is the AM2 (30A) fuse that is blowing, check the ignition condenser, capacitor, within the ignition assembly. I just removed it and assembled the ignition back together. I am in the process of ordering a new one from Rock Auto for a total of $2.57. It seems to be a common issue. The condenser is actually a capacitor and the issue is that they internally short.
Not finding what you are looking for?
1995 Toyota Corolla Logo

1,234 views

Ask a Question

Usually answered in minutes!

Top Toyota Experts

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6963 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15000 Answers

Greg Bernett
Greg Bernett

Level 3 Expert

2993 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...