Question about 2000 Subaru Forester

2 Answers

2000 subaru forester ignition coil wiring

2000 subaru forester does not start. has no spark.

Posted by Anonymous on

  • Anonymous Mar 18, 2010

    thanks for the advice. but i found the problem! customer installed a used motor from a 2005 forester- engine is the same but the cam and crank gear has sensor pick in different spots. replaced both gears and car runs good.

×

Ad

2 Answers

Anonymous

  • Level 1:

    An expert who has achieved level 1.

    New Friend:

    An expert that has 1 follower.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 10 Answers

Are there any other possible problems, or you are just not receiving spark at all now?

The coilpack could be dead and just need replaced. If you have a voltmeter or a test light, check the wiring on both sides of the coilpack harness to make sure it is receiving power.
I don't believe Subaru used ignitors past '99, but if they did, your should be located on the firewall behind the throttle body. Make sure it's plugged in and receiving power.

Coil packs do go bad from time to time. I had to replace mine in my
'98 Impreza a while back.

Goodluck!

Posted on Mar 16, 2010

Ad

Ronald tussey

  • Level 1:

    An expert who has achieved level 1.

    New Friend:

    An expert that has 1 follower.

  • Contributor
  • 1 Answer

Im not getting no fire to my coil pack on my 98 subaru impreza 2.2liter what could be the problem ??

Posted on Feb 11, 2014

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2000 2.5 motor


2000 Subaru Forester

for the easy solution download the pdf file

May 30, 2014 | 2000 Subaru Forester

1 Answer

Changed the alternator and starter and the timing belt on a 1998 subaru forester and it still wont start ...


If the engine cranks but won't start, the starter and alternator would not be the problem.
Was the engine running before you changed the timing belt ?
Do you have spark to the plugs and fuel to the injectors ?
Do you have normal compression on all cylinders ?

Jan 23, 2013 | 1998 Subaru Forester

1 Answer

2 flooding cyliders in subaru forester 2000 model engine is it computer related issues? problem happened under idle in extreme cold conditions whilst trying to warm engine


Hello...i'm here to help you, but need a bit more information please. Is the check engine light on in your Subaru? If so, do you know what the DTC codes are that caused it to come on? When you say "2 flooding cylinders" does that mean those 2 cylinders are not firing and the spark plugs are wet with gasoline? What 2 cylinders are they? I don't think the problem is ECM related. Reply back and i can give you some suggestions on where and what to troubleshoot.

Jul 12, 2011 | 2001 Subaru Forester

1 Answer

Engine hestitation, 2000 subaru forester


I think these codes are indicating a fault with your catalytic converter. The 02 sensors are each not returning the correct values to the ECM, causing a "suspect the 02 sensors" fault code.

Apr 01, 2010 | 2000 Subaru Forester

1 Answer

2000 subaru legacy stalls,jumpy, delayed when i give it gas


Oil leaking from old valve cover gaskets is common on Subaru engines. Once the plugs get oil on them it's best to replace the gasket, wires and plugs. Since that's been done, the next step would be a scan of live data to see what fuel trims and oxygen sensors and MAF sensor readings are. Also, a fuel pressure test. Until you do that, you really don't know what's going on. Don't replace any more parts until you get it diagnosed.

Sep 21, 2017 | 2000 Subaru Forester

1 Answer

2004 Subaru Forester: Can you safely install spark plugs without a torque wrench....just by using the "hand Tighten" directions on the package (1/2 to 2/3 turn)?.....Is the forester an iron or aluminum...


04 probly aluminum but i change spark plugs all day at work and just make sure there tight you dont need a torque wrench to put them in just sinch them down you will be fine.
good luck

Aug 24, 2009 | 2004 Subaru Forester

1 Answer

2000 Forester stalls when it rains


probably a ignition problem,start the engine and spray water on the ignition coil and spark plug wires you should see some lighting bolts!

Aug 06, 2009 | 2000 Subaru Forester

Not finding what you are looking for?
2000 Subaru Forester Logo

1,196 people viewed this question

Ask a Question

Usually answered in minutes!

Top Subaru Experts

Marvin
Marvin

Level 3 Expert

85239 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8984 Answers

Are you a Subaru Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...