Change a burned out low beam head light on a 2003

Have you tried changing bulbs? Usually one low beam burns out and you really don't notice so when the second one burns out it looks like a serious problem. There is no fuse for the headlights if it's not the bulb the next thing to check is the dimmer switch. I hope this helps. Take care.

I have changed the head lights in are Equinox several times. They work great for some time I would say after 4 mouths 1 will burn out . The low beam. I will change both lights. again not touching the leans putting them in with a clean rag.work great then in about 3 mouths the other side low beam will burn out. Again taking both out. I bought the best you can buy lights put them in September. 1 day the 1 burned out the next day the other side burned out low beam. So on March 3,I put in 2 new one's. again crossing my fingers. I'm almost redy to go to the dealer on this one. any idea's. Need help with my 2007 Equinox in Pa. Thanks Roger

the low high switch is bad,change as a unit with the turn signal lever. not bad to change.

The wiring harnesses in the plugs behind the bulbs are burned up seperate rear of headlight cover and inspect parts available at your ford dealer

YEP SOMETIMES THE BRASS CONNECTOR IS BAD IN THE LIGHT WHEN INSTALLING A NEW LIGHT MAKE SURE THAT THE CONNECTION IS GOOD AND TIGHT ALSO USE DIELECTRIC GREASE WHICH WILL HELP KEEP THE CONNECTION CLEAN

its kind of uncommon but I have seen both Low Beams burn out at the same time,but first check to see if your vehicle has a separate relay for the high beams and one for the low beams if so replace the low beam one if that is not replace both head lights,and it that is not it the only thing left is the head light switch itself.Hope this helps good luck

chek fuse or drl module is gone

2003 s10 replace low beam bulbs, was 2 clips that are attached that you pull up and the head light will tilt forward, to replace pulp,

I am assuming that you have a burned out head light bulb.
1) Open hood.
2) Working in back of headlight assembly, grasp rear of bulb socket (harness connector) and turn counterclockwise 90 degrees. Pull bulb out of headlight assembly.
3) Disconnect harness connector from bulb (gently pry, it's plastic)
4) Installation is reverse of removal. (Do not touch halogen bulb with bare skin-oils from hand will cause bulb to burn out.) Align tabs on bulb base to cutouts on rear of lens assembly. (Note bottom tab is wider than other two) Secure bulb by rotating clockwise 90 degrees.
Low beam bulb H9006
High beam bulb H9005

Check the dimmer switch.