Question about 2002 Jeep Liberty

2 Answers

Codes don't show up

I ran a diagnostic tool for my Liberty 2002 because the engine light came on. It showed the codes P0500, P1507, P1540 but there's no info on the codes on the Jeep site. Any help is appreciated.

Posted by Anonymous on

  • 1 more comment 
  • Anonymous Feb 25, 2010

    2wd

    meanwhile, i found out what the codes mean, but now i have to figure out what to do next.
    0500 vehicle speed sensor
    1507 idle air control
    1540 air intake

  • Anonymous Feb 25, 2010

    2wd

    meanwhile, i found out what the codes mean, but now i have to figure out what to do next.
    0500 vehicle speed sensor
    1507 idle air control
    1540 air intake

  • Anonymous May 11, 2010

    is this sport 2wd or 4wd

×

Ad

2 Answers

GetMeOttaHere

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 2,926 Answers

P500=Vehicle Speed Sensor Malfunction (VSS)
p1540=VSS Signal Too High
P1507= Vehicle speed/Idle Speed Actuator
Speed sensor is faulty or has a bad connection.

Posted on Feb 25, 2010

Testimonial: "Thank you. All of this is very helpful. I will look into doing the actual repair work required tomorrow. "

  • GetMeOttaHere Feb 25, 2010

    To start, check the connection on the VSS on the trans. Make sure it is clean and secure. Do you have an OBDII diagnostic scanner? If not, you can try replacing the VSS. I would also like to add that the code p1507 is related to the VSS code. Don't replace the idle speed actuator just yet.

×

Ad

Anonymous

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 9 Answers

Try clearing codes. 2 of 3 related to airfuel mixture and can be set off by gas cap challenge. if same codes come back diagnose further

Posted on Feb 25, 2010

×

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Speed Sensor A


Hi Daron below are 3 short youtube videos showing the reason you have error code p0500 speed sensor code.......Hope this helps...
CHEERS..
https://www.youtube.com/watch?v=6ltIw-xzwKY

https://www.youtube.com/watch?v=h_bf_QitHGs

https://www.youtube.com/watch?v=KE64o3NAdkY


Mar 26, 2016 | Jeep Cars & Trucks

1 Answer

How do i fix my Mercury Villager 2002 with random misfire?


How to Fix error code P0300 for random misfires on your car ...

diy-auto-repair.wonderhowto.com/.../fix-error-code-p0300-for-random-...
Oct 15, 2010 - How to Fix error code P0300 for random misfires on your car ... amisfire (code P0304) on a 1999 Mercury Villager 3.3L · How to Fix error code P0500 ... I reset my codes and it ran fine for a couple of days, then I started getting ...

(code P0305) on a 1999 Mercury Villager 3.3L - auto repair

diy-auto-repair.wonderhowto.com/.../troubleshoot-misfire-code-p0305-1...
Sep 7, 2010 - The vehicle is a '99 Mercury Village, 3.3L, with 150000 miles on it. The chief ... How to Fix error code P0300 for random misfires on your car ...

2000 Villager Misfire - Car Forums and Automotive Chat ...

www.automotiveforums.com > ... > Mercury > Villager
May 24, 2010 - 2000 Villager Misfire Villager Car Forums. ... i was told that the 3.3L engines of 1999-2002 nissan quests/ mercury villagers are INTERFERENCE engines! ... Hope the following may help, and I will post if my last fix works. ... I have a 1999mercury villager that is showing a random multiple cylinder misfire ...

Rough Idle - 2000 Mercury Villager - RepairPal

repairpal.com > Questions > Mercury > Villager > 2000 Mercury Villager
Repair the code issue, because your Villager has OBD-II which is a very helpful Diagnostic system. Upvote (4) ... My 1999 Villager was running poorly; rough idle, lack of power at highway speeds and the engine problem light indicated random miss-fire, etc. I had new spark ... Have code po306 cylinder 6 misfire detected.

P0301 - OBD-II Trouble Code - RepairPal


Dec 17, 2015 | 2002 Mercury Villager

1 Answer

Luz marcada con el numero cinco?


2003 Jeep Liberty- Reading Engine / Diagnostic Codes ...

? 1:13
https://www.youtube.com/watch?v=pGrPBBzp7wE
Jan 6, 2013 - Uploaded by DeathScouter
2003 Jeep Liberty- Reading Engine / Diagnostic Codes ..... error code will flash 2 times, brief pause, flash 1 time, pause, flash 5times, pause, ...

2005 Jeep Liberty possible cause of P0442 error. - YouTube

? 5:26
https://www.youtube.com/watch?v=2ba-gH0gadg
Dec 21, 2014 - Uploaded by TheBGravit
While replacing a bad fuel pump I believe I found the cause of a P0442 Error code. I was able to repair the ...

Jeep Liberty Questions - Cylinder Misfire code - CarGurus

www.cargurus.com > Questions > Jeep > Liberty

CarGurusMay 27, 2009 - My jeep Liberty 2009 does the same the Dashboard showed a code of cylinder .... i have a jeep liberty 2006 with the # 5 cylinder misfire. i replaced the sparks... I have a 2005 Jeep Liberty 6 cylinder, engine light came on scaned the ... 2002 jeep liberty camshaft posistion sensor error code p0340 5 answers.

Check Engine Light/Misfire Due to Intake Valve Locks ...

repairpal.com > Problems > Jeep > Liberty
Recently got a second hand 2005 Jeep Liberty Sport. Everything worked fine ... #5intake valve seat dropped and held open the intake valve. 2008 Jeep Liberty.

OBD-II Trouble Code: P0305 Cylinder 5 Five Misfire Detected

www.obd-codes.com/p0305


Dec 08, 2015 | 2005 Jeep Liberty

1 Answer

Code p1540


Google your codes & read up on the issues

Type: OBD & your codes

Codes do not indicate the need to replace parts

All parts have to be component tested,thus a repair
shop will be needed

May 02, 2014 | Subaru Legacy Cars & Trucks

1 Answer

2003 Dodge Caravan....all lights on the gears stay lit up...tranny shifting gears on its own....works sometimes other times tranny quits on you...dash lights stay light when even the key is removed from...


It's possible this is all caused by failure of the vehicle speed sensor circuit. The circuitry on the 4-cylinder is different from the V-6. Which engine do you have?

Aug 18, 2017 | Dodge Caravan Cars & Trucks

1 Answer

I have a 1998 subaru legecy 2.2 and check engine light is blinking the codes p0120 p0121 p0500 p1540 come up what now


Take it to a Autozone parts store or a large parts store and have them hook up their hand held analyzer and read those codes. they will then give you a printout of what they mean. All for free. take care, and good luck

Feb 05, 2011 | 1998 Subaru Legacy

2 Answers

I have a 2002 ford taurus. check engine light is on. Auto Zone did a scan today and the error code was p1507 can you please tell me what i need to do to fix this problem.


possible problems

Vaccuum leak
failed IAC valve
open or short
air inlet plugged

P1507 means "Idle Air Control Underspeed Error". It can be most commonly caused by a vacuum leak, a damaged Idle Air Control (IAC) assembly or a stuck IAC valve that needs cleaning. Essentially, your engine isn't idling at high enough according to your computer's programming parameters. Many times this shows up in colder weather as you try and start your vehicle. It will usually die unless you put your foot on the gas pedal and raise the RPM's. I have also read where a clogged air filter might be the problem. I would try cleaning your IAC valve first.

Oct 14, 2010 | 2002 Ford Taurus

1 Answer

My check engine light came on today and I stopped at a local garage. They ran a diagnostic that showed error P1529 / VIA CAN. Can you tell me what the problem is? All the notes on the web speak of just the...


Code P1529 sets in the ECM (Engine Control Module) to advise that the TCM (Transmission Control Module) requested the ECM to turn on the MIL (Malfuntion Indicator Light). What this means is there's a transmission code set in the TCM. You will need a manufacturer specific scan tool to pull Transmission codes and find out what's wrong with the trans. Some aftermarket scanners/code pullers only have the capability to pull Engine codes. -hope this helps

Feb 06, 2010 | 2002 Hyundai Accent

2 Answers

2002 DODGE GRAND CARAVAN STUCK IN 2ND/3RD, NO SPEEDOMETER...


the tcm is located in the fender well behind the bumper drivers side black box check the wiring for bad cannection,

let us know what you find there are thousands of us with the same problem

dan

Aug 13, 2008 | 2002 Jaguar X-Type

Not finding what you are looking for?
2002 Jeep Liberty Logo

670 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

Marvin
Marvin

Level 3 Expert

85239 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8984 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...