Hello, whenever the check engine light comes on the cruse light will flash as well, that is normal. The check engine light will not come on if fluid levels are low or if the temp is getting to high, I am pleased to know that you checked all of the fluids, most wouldn't have even the slightest thought to even try checking them. The On Board Diagnostics or OBD-2 for short only sets a check engine light when the ECM or Electronic Control Module reads a sensor value either too high or too low, but it has to read that same fault 3 consecutive times in a row to turn on the check engine light (w/ flashing cruise). Otherwise your check engine light would be going on and off all the time. I would go to your local parts store and have them check the codes for free because a dealer will have to charge you labor for them to check due to the knowledge needed to use the highly sophisticated scan tool they use. That way you can go either to an independent shop or a dealer with what the other scanner says is wrong which cuts down on the cost of repairs. They will probably ask you if you fueled up just before the engine light came on, in which that would be code P0440:EVAP leak(very small leak), that means the fuel tank sensor doesn't like how you put the fuel cap on. Subaru recommends AT LEAST 3 clicks when tightening your fuel cap. But until that code is checked you won't know whats wrong, if nothing went boom or bang you'll probably be ok. If it does end up being a fuel cap leak, then just loosen the cap put it back on and just make 1 full revolution, and just keep driving it. The light will go off within 3 full warm up cool down cycles or (drive cycles). I hope this info helps...(subyguru)...
1,597 views
Usually answered in minutes!
×