Question about 2004 Land Rover FreeLander

1 Answer

Rear wiper scrapes bodywork on my freelander 1

Posted by g_s_roberts on

Ad

1 Answer

Anonymous

  • Level 1:

    An expert who has achieved level 1.

    New Friend:

    An expert that has 1 follower.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 5 Answers

It looks like you need a new wiper arm ebay 15 quid . As they get old due to been plastic and a strong spring pushing them onto the rear screen . the arm tends to deform on the bend at the bottom causing the arm to scrape the body

Posted on Mar 20, 2010

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1990 voyager some time will not turn over battery when you turn key. radio, front & rear wipers, rear gate, also. but ac, window, lights in and out horn, after 1/2 hour or so will start.


Start by removing battery terminals and scraping/cleaning the terminals and connectors thoroughly. Put it back together and try your luck. Some folks like to soak in coca cola since that is all that coke is good for.

Apr 25, 2014 | 1990 Plymouth Voyager

1 Answer

How do you change the rear wiper blade of a Freelander?


You have to unclip it. Usually by pushing wiper blade to right (pass side) while holding wiper arm. Look to bottom side (facing window) some have small plastic button molded into them you have to push to release.

Feb 25, 2011 | 2005 Land Rover Freelander

1 Answer

1 window wiper working


Check to see if the nut that holds the wiper arm at its base has come loose. tighten to spec. this will happen if you run youe wipers when the are frozen to the windshield. (or shall a say windscreen, it is a british vehicle)

Dec 18, 2010 | 2003 Land Rover Freelander

1 Answer

Freelander td4 04 plate - passenger windscreen wiper has stopped working drivers is ok???


check to make sure that the COUPLER(it makes the 2 units work as 1) is not disconnected.It's probably under the windshield vent screen.

Mar 26, 2010 | 2004 Land Rover FreeLander

1 Answer

I got plm with freelander window wiper


get a new wiper motor its not the switch trust me

Jan 19, 2010 | 2002 Land Rover Freelander

2 Answers

Replaced battery on freelander rear window will not stay up carried out procedure in manual but window goes up beeps and goes down.no problem at all untill battery replaced.


disconnect battery reconect after 5 mins on reconnection rear window will go down , use key in rear lock to reset rear window, door lock should now work, if not try rear door relays behind left hand rear panel.

Jun 13, 2009 | 2002 Land Rover Freelander

1 Answer

Hi ,, I need to know if my alarm is turned of or if the module is bad in my land rover freelander. can some one tell me where i can find it


The Haynes manual says the following:-
The central contol unit (CCU) is located in the back of the fusebox below the driver's side fascia. If a fault develops you have to use a LR delaer to use the diagnostics. The unit controls the anti-theft, windscreen wipers, courtesy lamp delay, door opening warning lamp, key-in alarm,rear foglights, light-on alarm, seat belt warning, handbrake warning, rear screen wiper, tailaget window and many others.
Section 12.20 has a whole section on the alarm. The key fob alarm handset contains a transponder which talks to a reader in the ignition switch. So the immobiliser will cut in if the ignition key and the key fob are not on the same key ring.

Mar 31, 2009 | 2002 Land Rover Freelander

2 Answers

Location of air filter on landrover freelander td4


Find the air intake pipework that runs across the front of the engine and turns towards the rear of the vehicle and terminates in the air filter housing. loosen the fixings on this intake pipework and remove it completely, remove the oil filler cap and plug the hole with a rag to prevent contamination, remove the cover that had the oil filler cap mounted on, this involves the removal of 3 allan screws that are easily visable (more or less in line with the oil filler) then remove another 2 a;;an screws holding the rear of this cover these can be difficult to access as they are close to the bodywork below the windshield, this cover should now lift clear to allow access to the air filter, refitting is just a reversal of the above procedure, it is a good idea to remove any loose dirt before refitting the new filter by using a vacuum cleaner.

Mar 30, 2009 | 2005 Land Rover Freelander

Not finding what you are looking for?
2004 Land Rover FreeLander Logo

Related Topics:

187 people viewed this question

Ask a Question

Usually answered in minutes!

Top Land Rover Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Marvin
Marvin

Level 3 Expert

85239 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8984 Answers

Are you a Land Rover Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...